User manual SHARP CAROUSEL R-1480 CAROUSEL R-1481 @@ CAROUSEL R-1482

[. . . ] Do not connect the grounding wire to gas pipe, water pipe, lightning rod or telephone grounding wire. A burning smell), stop the operation immediately and turn the circuit breaker OFF. The appliance shall be installed in accordance with national wiring regulations. Improper cable connection can cause the power supply cord, plug and the electrical outlet to overheat and cause fire. [. . . ] Also, protect the unit and remote control from moisture and shock which can discolour or damage them. Example: 5 o'clock in the afternoon 1 To set to the 12-hour mode, press the CLOCK button once in the first step. 2 3 1 To set to the 24-hour mode, press the CLOCK button twice in the first step. In the AUTO and DRY mode, the temperature can be changed in 1°C increments within the range of 2°C higher to 2°C lower from the temperature automatically determined by the air conditioner. ⷠIn the COOL and HEAT modes, the temperature can be set within the range of 18 to 32°C In the DRY mode, the fan speed is preset to AUTO and cannot be changed. In the AUTO mode, the temperature setting and mode are automatically selected according to the room temperature and outdoor temperature when the unit is turned on. During operation, if the outdoor temperature changes, the temperature settings will automatically slide as shown in the chart. The indicator panel will change each time you press the DISPLAY button in the following manner. The displayed temperatures are rough estimates and may vary from the actual temperatures. ⷠTemperature display ranges Room temperature: 0°C ~ 40°C ( is displayed when less than 0°C and when higher than 40°C) Outdoor temperature: -9°C ~ 45°C ( is displayed when less than -9°C and when higher than 45°C) · Is displayed during the first 60 seconds of operation while the temperatures are being detected. ⷠOnly the room temperature can be displayed for 5 seconds when the unit is not in operation. It is said that plenty of negative ions exist in places such as waterfalls or waterside in natural environment. In this operation mode, negative ions will be released in an increased rate, in order to bring the room air close to this condition. Plasmacluster Operation will be performed with FAN or HEAT mode, in order to reduce the growth of mold fungus, and dry inside of the air conditioner unit. You can choose AIR CLEAN OPERATION or ION BALANCE OPERATION operation, press the 1 During to select the mode. In the AIR CLEAN operation, the blue PLASMACLUSTER lamp on the unit will light up. ⷠIn the ION BALANCE operation, the green PLASMACLUSTER lamp on the unit will light up. Press the PLASMACLUSTER button until PLASMACLUSTER symbol on the remote control display goes off. Setting of the PLASMACLUSTER operation will be memorized and will operate in the same mode, the next time you turn on the air conditioner. When the PLASMACLUSTER button is pressed while the unit is not operating, the PLASMACLUSTER operation will be performed without accompanying air conditioning mode (eg, HEATING or COOLING). The mode symbol of the remote control will go off and the fan speed can not be set AUTO. Before setting the timer, make sure the clock is properly set with the current time. [. . . ] ⷠEither timer can be programmed to activate prior the other. The red OPERATION lamp ( ) on the unit will light and the unit will start operating in the AUTO mode. ⷠThe fan speed and temperature setting are set to AUTO. Be sure to disconnect the power cord from the wall outlet or turn off the circuit breaker before performing any maintenance. [. . . ]