User manual SHARP AY-ZP40KR

[. . . ] Pulling and misuse of the power supply cord can result in damage to the unit and cause electrical shock. Be careful not to expose your body directly to the outlet air for a long time. When using the air conditioner for infants, children, elderly, bedridden, or disabled people make sure the room temperature is suitable for those in the room. Inserting objects can result in injury due to the high speed rotation of internal fans. [. . . ] Make sure to connect the air conditioner to power supply of the rated voltage and frequency. Use of a power supply with improper voltage and frequency can result in equipment damage and possible fire. ⷠDo not install the unit in a place where inflammable gas may leak. Install the unit in a place with minimal dust, fumes and moisture in the air. Upper limit COOLING lower limit upper limit HEATING lower limit 32°C 21°C 27°C 46°C 21°C 24°C -7°C · The built-in protective device may prevent the unit from operating when used out of this range. ⷠCondensation may form on the air outlet if the unit operates continuously in the COOL or DRY mode when humidity is over 80 percent. This air conditioner has a memory function to store settings when a power failure occurs. After power recovery, the unit will automatically re-start in the same settings which were active before the power failure, except for timer settings. If the timers were set before a power failure, they will need to be re-set after power recovery. In the HEAT operation, the indoor fan may not start for two to five minutes after the unit is turned on to prevent cold air from blowing out of the unit. When ice forms on the heat exchanger in the outdoor unit during the HEAT operation, an automatic de-icer provides heat for about 5 to 10 minutes to remove the ice. ⷠThe unit can be affected by signals transmitted from the remote control of a television, VCR or other equipment used in the same room. ⷠDo not leave the remote control in direct sunlight or near a heater. Also, protect the unit and remote control from moisture and shock which can discolour or damage them. The temperature can be changed in 1°C increments within the range of 2°C higher to 2°C lower from the temperature automatically determined by the air conditioner. In the AUTO mode, the temperature setting and mode are automatically selected according to the room temperature when the unit is turned on. In the DRY mode, the fan speed is preset to AUTO and cannot be changed. The adjusted position will be memorized and will be automatically set to the same position when operated the next time. The adjustment range is narrower the SWING range in order to prevent condensation from dripping. Manual adjustment of the vertical adjustment louvre can cause the unit to malfunction when the remote control is used for adjustment. ⷠWhen the vertical adjustment louvre is positioned at the lowest position in the COOL or DRY mode for an extended period of time, condensation may result. Do not adjust the horizontal adjustment louvre to the extreme left or right in the COOL mode with the fan speed set to "SOFT( )" for an extended period of time. [. . . ] ) on the unit will light · TURBO operation will also be cancelled when the operation mode is changed, or when the unit is turned off. ⷠAfter the unit has run for 30 minutes in TURBO operation, the fan setting will become the "HIGH" speed, and temperature setting will become 18°C in COOL and DRY modes. When the ONE-HOUR OFF TIMER is set, the unit will automatically turn off after one hour. ) on the unit will turn Alternatively, turn the unit off by pressing the ON/OFF button. [. . . ]