User manual SHARP AY-XPC7JR/9JR/12JR

[. . . ] Attention: If you want to dispose of this equipment, please do not use the ordinary dust bin!Used electrical and electronic equipment must be treated separately and in accordance with legislation that requires proper treatment, recovery and recycling of used electrical and electronic equipment. Following the implementation by member states, private households within the EU states may return their used electrical and electronic equipment to designated collection facilities free of charge*. In some countries* your local retailer may also take back your old product free of charge if you purchase a similar new one. [. . . ] The filters are sealed in a plastic bag to keep their dust collection effect. If the AUX button is pressed during normal operation, the unit will turn off. The temperature can be changed in 1°C increments within the range of 2°C higher to 2°C lower from the temperature automatically determined by the air conditioner. In the DRY mode, the fan speed is preset to AUTO and cannot be changed. When using your air-conditioner with multi-system With a multi system air conditioner, multiple indoor units can be connected to one outdoor unit. When the setting mode differs among indoor unit(s), the indoor unit(s) operated later may not work. ⷠWhen the indoor unit(s) is/are operating in HEAT mode, the remaining unit(s) can not operate in COOL or DRY mode. ⷠWhen the indoor unit(s) is/are operating in COOL or DRY mode, the remaining unit(s) can not operate in HEAT mode. When the mode of the indoor unit(s) later operated is/are different from those which is/are in operation, after a few seconds, a long BEEP will be emitted and the temperature indicator " and on the indicator panel will indicate" the OPERATION lamp and TIMER lamp will blink alternately. In such case, change the mode to the same mode which the other indoor unit(s) is/are operating in. The adjusted position will be memorized and will be automatically set to the same position when operated the next time. In the AUTO mode, the temperature setting and mode are automatically selected according to the room temperature and outdoor temperature when the unit is turned on. ⷠDuring operation, if the outdoor temperature changes, the temperature settings will automatically slide as shown in the chart. When using your air-conditioner with multisystem, mode of the unit operated first will have priority over other unit(s) without reference to the above chart. Manual adjustment of the vertical adjustment louvre can cause the unit to malfunction when the remote control is used for adjustment. ⷠWhen the vertical adjustment louvre is positioned at the lowest position in the COOL or DRY mode for an extended period of time, condensation may result. Do not adjust the horizontal adjustment louvre to the extreme left or right in the COOL mode with the fan speed )" for an extended period of time. Press the PROGRESSIVE AIRFLOW button during cooling or dry operation when you do not want to feel cold air. Vertical adjustment louvre is set downward to deliver the warm air down to the floor and warm you. In this operation, the air conditioner works at the maximum power to makes the room cool or warm so rapidly that you can use it just after you come home. FULL POWER operation will also be cancelled when the operation mode is changed, or when the unit is turned off. ⷠThe green FULL POWER lamp ( ) on the unit will turn off. [. . . ] A LOW BUZZING NOISE EMITTED This is a sound emitted when the unit is generating Plasmacluster ions. SWISHING NOISE The soft, swishing noise is the sound of the refrigerant flowing inside the unit. wATER VAPOUR · In the COOL and DRY operation, water vapour can sometimes be seen at the air outlet due to the difference between the room air temperature and the air discharged by the unit. ⷠIn the HEAT operation, water vapour may flow out of the outdoor unit during de-icing. [. . . ]