User manual SHARP AY-9FHR

[. . . ] It means that used electrical and electronic products should not be mixed with general household waste. If your used electrical or electronic equipment has batteries or accumulators, please dispose of these separately beforehand according to local requirements. By disposing of this product correctly you will help ensure that the waste undergoes the necessary treatment, recovery and recycling and thus prevent potential negative effects on the environment and human health which could otherwise arise due to inappropriate waste handling. In other Countries outside the EU If you wish to discard this product, please contact your local authorities and ask for the correct method of disposal. [. . . ] ⷠMake sure there is no curtain or other object between the remote control and the unit. ⷠThe remote control can send signals from up to 7 metres away. Do not allow the signal receiver window to receive strong direct sunlight, since it can adversely affect its operation. If the signal receiver window is exposed to direct sunlight, close a curtain to block the light. ⷠUsing a fluorescent lamp with a quick starter in the same room may interfere with transmission of the signal. ⷠThe unit can be affected by signals transmitted from the remote control of a television, VCR or other equipment used in the same room. ⷠDo not leave the remote control in direct sunlight or near a heater. Also, protect the unit and remote control from moisture and shock which can discolour or damage them. Example: 5 o'clock in the afternoon 1 To set to the 12-hour mode, press the CLOCK button once in the first step. 2 3 1 To set to the 24-hour mode, press the CLOCK button twice in the first step. The temperature can be changed in 1°C increments within the range of 2°C higher to 2°C lower from the temperature automatically determined by the air conditioner. ⷠThe green FULL POWER lamp ( ) on the unit will turn off. You can not set the temperature or fan speed during the FULL POWER operation. The Plasmacluster Ion generator inside the air conditioner will release positive and negative plasmacluster ions into the room. Approximately the same numbers of positive and negative ions released into the air will reduce some airborne mold. Use of the PLASMACLUSTER operation will be memorized, and it will be activated the next time you turn on the air conditioner. When the PLASMACLUSTER button is pressed while the unit is not operating, the PLASMACLUSTER operation will be performed without accompanying air conditioning mode (eg, HEATING or COOLING). The mode symbol of the remote control will go off and the fan speed can not be set AUTO. SELF CLEAN operation will provide effect to reduce the growth mold fungus, and to dry inside of the air conditioner unit with Plasmacluster ions. ⷠYou cannot set the temperature, fan speed, air flow direction or timer setting during the SELF CLEAN operation. When the ONE-HOUR OFF TIMER is set, the unit will automatically turn off after one hour. ⷠThe red OPERATION lamp ( ) and the orange TIMER lamp ( ) on the unit will turn off. [. . . ] The unit employs a heat pump that draws heat from the outside air and releases it into the room. The outside air temperature therefore greatly affects the heating efficiency. ⷠIf the heating efficiency is reduced due to low outside temperatures, use an additional heater. ⷠIt takes time to warm up and heat the entire room because of the forced air circulation system. [. . . ]