User manual SHARP AR-M350 OPERATION MANUAL (PRINTER)

[. . . ] The symbol " " denotes the copier is not completely de-energized but in a stand-by condition at this "POWER" switch position. If your copier is so marked, please read "I" for "ON" and " " for "OFF". The socket-outlet shall be installed near the equipment and shall be easily accessible. The CE mark logo label is affixed on an equipment in case that the directives described in the above sentence are applicable to the product. (This sentence is not applicable in any country where the above directives are not required. ) Note: When this equipment is equipped with a multi-function controller board which allows the equipment to include copier, facsimile, and network scanning capabilities, the following text will be applied. [. . . ] This License allows you to use the Software on one or more computers connected to a single printer and make one copy of the Software in machine-readable form for backup purposes only. You must reproduce on such copy the SHARP copyright notice, the copyright notice of SHARP'S Licensors and any other proprietary legends of SHARP and/or its Licensors that were on the original copy of the Software. You may also transfer all your license rights in the software, the backup copy of the Software, the related documentation and a copy of this License to another party, provided the other party reads and agrees to the terms and conditions of this License. The Software contains copyrighted material, trade secrets and other proprietary material which is owned by SHARP and/or its Licensors and in order to protect them you may not decompile, reverse engineer, disassemble or otherwise reduce the Software to a human-perceivable form. You may not modify, network, rent, lease, loan, distribute or create derivative works based upon the Software in whole or in part. You may not electronically transmit the Software from one computer to another or over a network. You may terminate this License at any time by destroying the Software and related documentation and all copies thereof. This License will terminate immediately without notice from SHARP and/or SHARP'S Licensors if you fail to comply with any provision of this License. Upon termination you must destroy the Software and related documentation and all copies thereof. You agree and certify that neither the Software nor any other technical data received from SHARP nor the direct product thereof, will be exported outside the United States except as authorized and as , permitted by the laws and regulations of the United States. If the Software has been rightfully obtained by you outside of the United States, you agree that you will not re-export the Software nor any other technical data received from SHARP nor the direct product thereof, except as permitted by the laws and regulations of the United states and the , laws and the regulation of the jurisdiction in which you obtained the Software. If you are acquiring the Software on behalf of any unit or agency of the United States Government, the following provisions apply. The Government agrees: (i) if the Software is supplied to the Department of Defense (DoD), the Software is classified as "Commercial Computer Software" and the Government is acquiring only "restricted rights" in the Software and its documentation as that term is defined in Clause 252. 227-7013 (c)(1) of the DFARS; and (ii) if the Software is supplied to any unit or agency of the United States Government other than DoD, the Government's rights in the Software and its documentation will be as defined in Clause 52. 227-19 (c)(2) of the FAR or, in the case of NASA, in Clause 18-52. 227-86 (d) of the NASA Supplement to the FAR. SHARP warrants the disks on which the Software is recorded to be free from defects in materials and workmanship under normal use for a period of ninety (90) days from the date of purchase as evidenced by a copy of the receipt. The entire liability of SHARP and/or its Licensors and your exclusive remedy will be replacement of the disk which fails to meet the limited warranty provided by this Clause 6. A disk will be replaced when it is returned to SHARP or a SHARP authorized representative with a copy of the receipt. SHARP will have no responsibility to replace a disk damaged by accident, abuse or misapplication. 2 ANY IMPLIED WARRANTIES ON THE DISKS, INCLUDING THE IMPLIED WARRANTIES OF MERCHANTABILITY AND FITNESS FOR A PARTICULAR PURPOSE, ARE LIMITED IN DURATION TO NINETY (90) DAYS FROM THE DATE OF DELIVERY. THIS WARRANTY GIVES YOU SPECIFIC LEGAL RIGHTS, AND YOU MAY ALSO HAVE OTHER RIGHTS WHICH VARY FROM JURISDICTION TO JURISDICTION. You expressly acknowledge and agree that use of the Software is at your sole risk. [. . . ] This License constitutes the entire agreement between the parties with respect to the use of the Software and related documentation, and supersedes all prior or contemporaneous understandings or agreements, written or oral, regarding such subject matter. No amendment to or modification of this License will be binding unless in writing and signed by a duly authorized representative of SHARP . 3 ADDING TONER When the toner cartridge becomes empty of toner, a message indicating the need to replace the toner cartridge will appear on the display. Follow step 4 below for installing the first cartridge. 1 Open the front cover. 5 Insert a new toner cartridge. Push the cartridge in until it locks securely into place. 2 Lower the cartridge lock lever. 6 Gently remove the sealing tape from the cartridge. 3 While depressing the lock release button, pull out the toner cartridge and remove it. 7 Return the cartridge lock lever. 4 Remove a new toner cartridge from the package and shake it horizontally five or six times. 8 Close the front cover. 4 CAUTION q If a cartridge is to be discarded, dispose of it according to local requirements. q Store toner cartridges out of the reach of children. NOTE Do not shake the toner cartridge after the sealing tape has been removed. [. . . ]