User manual SHARP AN-PH7LP1/LP2

[. . . ] LAMP UNIT (LAMP/CAGE MODULE) FOR PROJECTOR Model 4 Remove the lamp unit. · Loosen the securing screws (two for each lamp) from the lamp unit. Hold the lamp unit by the handle and pull it in the direction of the arrow. [. . . ] For the name of the nearest Sharp Authorized Projector Dealer or Service Center*, please call toll-free: 1-888-GO-SHARP (1-888-467-4277). 6 AN-PH7LP2 Replace the lamp unit cover. · Align the lamp unit cover and slide it to close. Then tighten the user service screw to secure the lamp unit cover. Hg LAMP CONTAINS MERCURY For State Lamp Disposal Information www. lamprecycle. org or 1-800-BE-SHARP * Confirm the name of the Dealer or Service Center referring to your projector operation manual. U. S. A. ONLY Info · If the lamp unit and lamp unit cover are not correctly installed, the power will not turn on, even if the power cord is connected to the projector. Removing and Installing the Lamp Unit Info · Ensure the lamp unit is removed using the handle. Ensure the glass surface of the lamp unit or the inside of the projector are not touched. · To avoid injury to yourself and damage to the lamp, be sure to carefully follow the steps below. · Do not loosen other screws except for the lamp unit cover and lamp unit. (Only the silver screws are loosened. ) STANDBY button For Lamp 1 For Lamp 2 Resetting the Lamp Timer Reset the lamp timer after replacing the lamp. Compartment for Compartment for AN-PH7LP1 AN-PH7LP2 User service screw Info · Make sure to reset the lamp timer only when replacing the lamp. If you reset the lamp timer and continue to use the same lamp, this may cause the lamp to become damaged or explode. To AC socket 1 Press on the projector or on the remote control to put the projector into standby mode. · Wait until the cooling fan stops. · Do not remove the lamp unit from the projector right after use. The lamp and parts around the lamp will be very hot and may cause burn or injury. Power cord 1 2 Connect the power cord. · Plug the power cord into the AC socket of the projector. Power cord Reset the lamp timer. For Lamp 1 · When you reset the timer for AN-PH7LP1, while simultaneously holding down and , ON button ENTER button MENU button H&V LENS SHIFT button 2 3 Disconnect the power cord. · Unplug the power cord from the AC socket. · Leave the lamp until it has fully cooled down (about 1 hour). 2 1 press on the projector. · "LAMP 1 100%" is displayed, indicating that the lamp timer is reset. For Lamp 2 · When you reset the timer for AN-PH7LP2, while simultaneously holding down and , Remove the lamp unit cover. · Loosen the user service screw (1) that secures the lamp unit cover. [. . . ] È inoltre possibile scaricare lo stesso manuale d'uso dal sito web (http://sharp-world. com/products/index. html). NEDERLANDS Verwijs naar de gebruiksaanwijzing die bij de projector wordt geleverd. U kunt de gebruiksaanwijzing ook vanaf internet downloaden (http://sharp-world. com/products/index. html). [. . . ]