User manual SHARP AL-1217D/1457D/1555

[. . . ] To ensure continued safety do not remove any cover or attempt to gain access to the inside of the product. The label ( ) in the fusing area of the unit indicates the following: : Caution, risk of danger : Caution, hot surface Follow the cautions below when using this unit. After turning the unit off, wait 10 to 15 seconds before turning it back on. When the unit is not used for a long time, for example for consecutive holidays, turn the power switch off and remove the power cord from the outlet. [. . . ] If you want only Button Manager to start in this case, set up Button Manager for use in Windows as explained in "Setting up the Button Manager" (p. If step 4 is performed with the "Show TWAIN setting screen when scanning" checkbox selected in the Scan Parameter Setting Dialog Box (p. Check the settings, and then press the start ( ) key again or click the "Scan" button in the TWAIN setting screen to start scanning. Opening the scanner driver and scanning from your computer Follow the steps below to open the scanner driver setup screen. As an example, this instruction is given using Sharpdesk as an image capture application. If you perform a pre-scan (see the online manual or the help file for the scanner driver), the original in the SPF/ RSPF will be output to the exit area after scanning. To scan the original after the pre-scan, place the original in the SPF/RSPF once again. If you use more than one scanning device, select the scanner you want to use through the application. the method for accessing the "Select Scanner" option , depends upon the application. For more information, see the online manual or the help file of your application. Click the "SHARP AL-xxxx" (where xxxx is the model name of your unit) icon and click "Get picture" in "Imaging Tasks". The online manual provides detailed instructions for operating the unit as the printer or scanner and a list of methods for dealing with printing or scanner problems. To access the online manual, your computer must have Acrobat Reader 5. SHARP recommends printing out the sections which you refer to regularly. If you use another GDI printer or a Windows Printing System printer, interference between printers may occur and printing may not be performed properly. To use another GDI printer or a Windows Printing System printer, you must change the port setting of the printer driver using the following procedure. If another printer does not operate properly when the SHARP Personal MFP series printer driver is set to "FILE" as described below, uninstall the SHARP Personal MFP series printer driver. Right-click the "SHARP AL-xxxx" (where xxxx is the model name of your unit) icon in the printer dialog box and then click "Properties". Click the "Ports" tab ("Details" tab - on Windows 95/98/Me) in the "Properties" dialog box, select "FILE:" in the "Print to the following port" list box, and click the "OK". right-click the icon of the printer to be used and click "Properties". Click the "Ports" tab ("Details" tab - on Windows 95/98/Me) in the "Properties" window, select "LPT1" (or the currently used port), and click the "OK" button. To use the SHARP Personal MFP series again, perform the same procedure but select the port to be used (for example, LPT1) in step 4. [. . . ] This License constitutes the entire agreement between the parties with respect to the use of the Software and related documentation, and supersedes all prior or contemporaneous understandings or agreements, written or oral, regarding such subject matter. No amendment to or modification of this License will be binding unless in writing and signed by a duly authorized representative of SHARP. As an ENERGY STAR® Partner, SHARP has determined that this product meets the ENERGY STAR® guidelines for energy efficiency. "This program is about to install Sharpdesk imaging, which does not support LZW compression. [. . . ]