User manual SEW-EURODRIVE 122

[. . . ] ZyXEL further reserves the right to make changes in any products described herein without notice. This publication is subject to change without notice. Trademarks ZyNOS (ZyXEL Network Operating System) is a registered trademark of ZyXEL Communications, Inc. Other trademarks mentioned in this publication are used for identification purposes only and may be properties of their respective owners. Copyright 2 Prestige 660H/HW Series User's Guide Federal Communications Commission (FCC) Interference Statement This device complies with Part 15 of FCC rules. Operation is subject to the following two conditions: · This device may not cause harmful interference. [. . . ] Select the check box to create a log (when the above action is taken) for packets that are traveling in the selected direction and do not match any of the rules below. Click Cancel to begin configuring this screen afresh. 13. 6 Rule Summary Note: The ordering of your rules is very important as rules are applied in turn. Click on Firewall, then Rule Summary to bring up the following screen. Note the order in which the rules are listed. Figure 65 Firewall: Rule Summary 149 Chapter 13 Firewall Configuration Prestige 660H/HW Series User's Guide The following table describes the labels in this screen. Table 41 Rule Summary LABEL Firewall Rules Storage Space in Use DESCRIPTION This read-only bar shows how much of the Prestige's memory for recording firewall rules it is currently using. When you are using 80% or less of the storage space, the bar is green. When the amount of space used is over 80%, the bar is red. Packet Direction Use the drop-down list box to select a direction of travel of packets for which you want to configure firewall rules. Default Policy This field displays the default action and log policy you selected in the Default Rule screen for the packet direction shown in the field above. The following read-only fields summarize the rules you have created that apply to traffic traveling in the selected packet direction. The firewall rules that you configure (summarized below) take priority over the general firewall action settings above. Click a rule's number to go to the Firewall Edit Rule screen to configure or edit a firewall rule. This drop-down list box displays the source addresses or ranges of addresses to which this firewall rule applies. Highlight a service from the Available Services box on the left, then click Add>> to add it to the Selected Services box on the right. To remove a service, highlight it in the Selected Services box on the right, then click Remove. Edit Customized Click the Edit Customized Services link to bring up the screen that you use to Service configure a new custom service that is not in the predefined list of services. Schedule Day to Apply Select everyday or the day(s) of the week to apply the rule. Time of Day to Select All Day or enter the start and end times in the hour-minute format to Apply (24-Hour apply the rule. Format) Log Log Packet Detail This field determines if a log for packets that match the rule is created (Enable) Information or not (Disable). Go to the Log Settings page and select the Access Control logs category to have the Prestige record these logs. Alert Send Alert Message Select the check box to have the Prestige generate an alert when the rule is to Administrator matched. When Matched Back Apply Cancel Delete Click Back to return to the previous screen. Click Delete to remove this firewall rule and return to the Firewall Rule Summary screen. 153 Chapter 13 Firewall Configuration Prestige 660H/HW Series User's Guide 13. 7 Customized Services Configure customized services and port numbers not predefined by the Prestige. For a comprehensive list of port numbers and services, visit the IANA (Internet Assigned Number Authority) website. [. . . ] A user was not authenticated by the local user database because of an incorrect user password. A user was not authenticated by the local user database because the user is not listed in the local user database. A user tried to use another authentication method and was not authenticated. The router logged out a user from which there was no authentication response. [. . . ]