User manual SEVERIN SM 9685

[. . . ] The appliance and its power cord must be kept well away from children under 8 at all times. The appliance may only be used by persons with reduced physical, sensory or mental capabilities, or lacking experience and knowledge, if they have been given supervision or instruction concerning the use of the appliance and fully understand all dangers and safety precautions involved. Caution: Keep any packaging materials well away from children: there is a risk of suffocation. [. . . ] For best results, the milk should be taken from the refrigerator immediately before frothing. The underside of the container and the contact area on the inside of the base must be clean and dry. Choosing the stirring head – Use the smooth stirring head to heat up milk. €“ For frothing and heating milk at the same time, use the serrated head. €“ When not in use, the stirring heads may be safely stored at the rear of the housing. Fill amounts – Always observe the minimum mark and ensure the container is filled with at least 100 ml milk. Place the appropriate head onto the mounting protrusion inside the bottom of the container. A beep signal is heard and the 65° C indicator starts flashing. Use the temperature selection button to set the desired temperature or the coldfrothing function (blue dot symbol). After a beep signal is heard, the indicator light for the selected temperature function shows a steady light and the cooling system of the motor is heard to start up. Once the milk is sufficiently hot or the cold-frothing process is complete, both heating and stirring processes stop automatically. The indicator light for the selected temperature function flashes, and a number of beep signals are heard. The temperature indicator lamp stops flashing after about three minutes. Been heated to 60° C (as indicated by the corresponding beep signals), take off the lid insert and add the required amount of cocoa powder. Now set the temperature selector to 65° C and press the On/Off switch again. To prevent any blockage or congestion, do not use grated chocolate or chocolate flakes when making cocoa. Interrupting or ending a cycle Press the On/Off switch to stop the heating and stirring process: The main indicator lamp starts flashing and the motor cooling system can be heard. To continue the heating and stirring process, Press the On/Off switch again. [. . . ] Fit the smooth stirring head and set the temperature selector to 60° C. As soon as the milk has 10 Disposal Do not dispose of old or defective appliances in domestic garbage; this should only be done through public collection points. Under this guarantee the manufacturer undertakes to repair or replace any parts found to be defective, providing the product is returned to one of our authorised service centres. [. . . ]