User manual SEVERIN KS 9888

[. . . ] If damage to the cooling circuit does occur, do not switch on or connect the appliance to the mains power. In the case that there is an open fire or any other sources of ignition in the vicinity of the refrigerant gas, make sure it is removed immediately from this area and that the room is then thoroughly ventilated. — Warning: Keep the ventilation openings in the appliance’s enclosure clear of obstruction. — Before it is connected to the mains power, the unit must be thoroughly checked for transport damage, including its power cord. [. . . ] 12 ● For each zone, the temperature range can be set between 4 °C and 18°C (40 °F and 65 °F). It is only switched off completely when the plug is removed from the wall socket. The actual temperature inside the cabinet is shown in the temperature display. The temperature settings for both zones can be adjusted using the -button (upper zone) and the -button (lower zone). The temperature can be changed in 1-degree steps (°C or °F). The temperature display format can be changed by pressing °F/°C. The selected format is indicated by the active light next to the appropriate temperature symbol. Changing the interior light bulb – Switch off the interior light. €“ Use a suitable screwdriver to remove the screw from the lamp cover (1). €“ Take off the lamp cover (1) by slightly pulling down its lower end. €“ Remove the defective bulb (2) from its housing (3) and fit a new 10W-bulb (max. €“ Slide the cover (1) back into position, replace the screw and tighten it. Storing wine – The temperature in the cabinet largely depends on factors such as the ambient temperature, the setting and the number of wine bottles stored. If the ambient temperature falls below 20 or exceeds 25°C, the maximum achievable storage temperature inside the unit can vary accordingly. €“ The following temperatures are suitable for various wines: Red: 15-18°C / 60-65°F Dry/white: 10-15°C / 50-59°F Sparkling/champagne: 7- 9°C / 45-49°F The specified temperature range may vary up or down as a result of outside factors such as the weather, the interior light being switched on, or the position of the bottles stored in the cabinet (top, bottom or middle). The vertical space between the storage racks can be modified to accommodate different-sized bottles by selecting the appropriate guide rails for each rack. Always ensure that the door is properly closed and that the seal is not obstructed by bottles stored inside the cabinet. €“ – – Door lock The door lock can be used to protect the cabinet against unauthorised use. We recommend that you remove the second key from the holder and store it in a safe place. This will also protect the housing against scratching caused by the second key dangling from the key holder. 13 De-frosting and cleaning The integral vaporiser is sealed in foam in the rear wall; you may therefore notice a build-up of frost around the rear area. This layer of frost will start melting when the compressor is not working. [. . . ] disposal This appliance has been manufactured from recyclable materials. After removing the plug from the wall socket, the unit should be rendered unusable by cutting off the power cord before being disposed of through special waste collection points in accordance with local regulations. The refrigerant and the chemical agent in the insulation foam must be disposed of through a competent agency. Take special care not to damage the cooling circuit before the unit is handed over for competent disposal. [. . . ]