User manual SEVERIN KS 9886

[. . . ] If damage to the cooling circuit does occur, do not switch on or connect the appliance to the mains power. If there should be an open flame or any other source of ignition in the vicinity of the refrigerant gas, make sure it is removed immediately from the area and that the room is then thoroughly ventilated. — Warning: Keep ventilation openings, in the appliance enclosure or in a built-in structure, clear of obstruction. A heater or heating fan) to accelerate defrosting; follow only the methods recommended in this manual. [. . . ] - Pull off the two bolts (7) which hold the lower hinge (4) in position on the right. - Unscrew the adjustable foot (8) and re-fit it on the right-hand side. Ensure that the hinge pin is inserted into the guide bushing (hole) on the lower part of the housing. - Install the upper hinge (3) on the left-hand side, using the screws (2). Ensure that the hinge pin is inserted into the guide bushing (hole) on the upper part of the housing. The bolts (7) should be tightened only after the door is closed and adjusted to its proper position. It is only switched off completely when the plug is removed from the wall socket. In position ‘0’, the cooling function is switched off, though the appliance is still connected to the mains. 11 The temperature in the cabinet can be adjusted by setting the temperature control. Turning the control clockwise will decrease the temperature, while turning it anti-clockwise will increase it. After switching on, the temperature control should be set to position 5. Following a power interruption, or if the unit has been switched off on purpose, always wait 3 to 5 minutes before switching on again. Storing wine - The temperature in the cabinet largely depends on factors such as the ambient temperature, the setting and the number of wine bottles stored. - Always ensure that the door is properly closed and that the seal is not obstructed by bottles stored inside the cabinet. De-frosting and cleaning The integral evaporator is sealed in foam within the walls; you may therefore notice a buildup of frost around the rear area. This layer of frost will start melting when the compressor is not working. Through a system of hoses, the melt-water drains into the collection tray below the compressor, where it will be absorbed into the surrounding air. The unit does not therefore require de-frosting, but only proper cleaning. — To enable the melt-water to drain freely, always ensure that the channel and discharge opening in the cabinet are free of any blockage. Cleaning the unit / periods of non-use - remove the plug from the wall socket - remove the bottles from the cabinet - leave the door open To prevent any unpleasant odour within the cabinet, it should be cleaned at least every two months. Take care not to remove or damage the rating plate inside the cabinet during cleaning. Any dust deposits around the ventilation slots on the outside of the unit should be regularly removed using a suitable brush or a vacuum cleaner. [. . . ] Take special care not to damage the cooling circuit before the unit is handed over for competent disposal. disposal This appliance has been manufactured from recyclable materials. Under this guarantee the manufacturer undertakes to repair or replace any parts found to be defective, providing the product is returned to one of 13 our authorised service centres. This guarantee is only valid if the appliance has been used in accordance with the instructions, and provided that it has not been modified, repaired or interfered with by any unauthorised person, or damaged through misuse. [. . . ]