User manual SEVERIN KS 9878

[. . . ] No responsibility is accepted if damage results from improper use, or if these instructions are not complied with. This appliance is intended for commercial Gas with a high level Therefore, that none of the components of The refrigerant circuit become damaged Circuit does occur, do not switch on or Connect the appliance to the mains power. In the case that there is an open fire or any other sources of ignition in the vicinity of the refrigerant gas, make sure it is removed immediately from this area and that the room is then thoroughly ventilated. Warning: Keep ventilation openings, in the appliance enclosure or in the built-in structure, clear of obstruction. [. . . ] It should be operated in conditions where the relative humidity is no more than 60 %. The product data sheet contains details of the ambient temperature range suitable for this appliance. Ensure that the plug is accessible and can be removed from the Wall socket at any time. Do not expose the appliance to direct sunlight, and do not Position it next to any heat sources (radiators, cookers etc). If this cannot be avoided, however, suitable insulation must be in installed between the heat source and the unit. The unit must not be installed inside a cabinet, nor directly below a hanging cupboard, shelf or similar object. If the unit is installed next to a wall, a minimum lateral distance of 10 mm is necessary for the door to fully open. If the floor is uneven, the adjustable feet on the unit can be used to compensate and ensure optimum stability. The heated air around the rear of the unit must be able to circulate freely. Warning: Take special care that the ventilation openings in the upper part of the rear panel are not blocked or obstructed. Temperature control The unit is activated by connecting it to the mains. it is only Switched off completely when the plug is removed from the wall socket. The green mains indicator light shows that the unit is connected to the mains. The temperature in the refrigerator cabinet can be adjusted by setting the temperature control (0-5). Turning the control clockwise will decrease the temperature, while turning it anticlockwise will increase it. The temperature in the cabinet largely depends on factors such as the ambient temperature, the setting and the number of bottles stored. We recommend using a thermometer to check the actual temperature inside the cabinet and make adjustments as necessary. Always ensure that the door is properly closed and that the seal is not obstructed by bottles stored inside the cabinet. Following a power interruption, or if the unit has been switched off on purpose, it may take 3 to 5 minutes before it switches on again. Note: With the temperature control in position `0', only the compressor is switched off, while the fan is still running. Interior lighting The interior light can be switched on by means of the separate On/Off switch. If there should be any malfunction, please contact the customer service for assistance. [. . . ] In case of problems or malfunction, or if spare parts are required, contact only the Service hotline. The actual consumption depends on the pattern of use and the location of the appliance Henvises til produktets datablad for information om klassificeringen for denne enhed. For at undgå risiko for personskade eller beskadigelse af apparatet, må apparatet kun transporteres mens det er pakket ind i den originale emballage. For at undgå brandfare, må man aldrig placere nogen form for termo-elektriske apparater ovenpå køleskabet. [. . . ]