User manual SEVERIN KS 9792

[. . . ] Dear Customer, Before using the appliance, please read the following instructions carefully and keep this manual for future reference. The appliance must only be used by persons familiar with these instructions. Connection to the mains supply The appliance should only be connected to an earthed socket installed in accordance with the regulations. Make sure that the supply voltage corresponds with the voltage marked on the rating label. [. . . ] Unscrew the hinge pin (15) from the bracket, and re-insert it from the other side. Remove both screws on the left of the underside and replace them on the right. Remove the cap (19) from the freezer door and the cap (16) from the refrigerator door and replace them on the opposite side of the doors. Take off the caps (17) from the partition between the refrigerator and freezer compartments and remove the screws. Fit the refrigerator door (13) onto the pin (15) of the lower hinge bracket. Fit the pin of the centre hinge bracket (10), together with the washers, to the refrigerator door (13). Fit the centre hinge bracket (10) together with the plastic plate (9). Place the freezer door (18) onto the pin of the centre hinge bracket (10). Fit the pin of the upper hinge bracket (5) to the freezer door (18), and then fit and secure the upper hinge bracket (5). Note: If necessary, the alignment of the doors can be adjusted by slightly loosening the hinge bracket screws, but remember to tighten them afterwards. Replace the top cover (4) and use the screws (1 and 3) to secure it (two screws at the front and two at the rear). Fit the two enclosed spacer elements (2) into the corresponding guide slots on the rear). If the unit has been tilted to more than 30°, wait for about 4 hours before re-connecting it to the mains. Temperature control The unit is re-activated by connecting it to the mains. It is only switched off completely when the plug is removed from the wall socket. The temperature in the refrigerator cabinet can be adjusted by setting the temperature control. Turning the control clockwise will decrease the temperature, while turning it anti-clockwise will increase it. We recommend using a thermometer to check the actual temperature inside the cabinet and make adjustments as necessary. Following a power interruption, or if the unit has been switched off on purpose, it may take 3 to 5 minutes before it switches on again. In position `0', the cooling function is switched off, though the appliance is still connected to the mains. Interior lighting Changing the light bulb: Remove the plug from the wall socket. Use a suitable tool to release the locking tab (5) and remove The lamp cover (4). [. . . ] The following table lists possible malfunctions and their probable causes and solutions. In the event of operational problems, check first whether a solution can be found using this table. If the problem persists, disconnect the appliance from the mains power and contact our Customer Service Department. This can be checked by Connecting another electrical device to the socket and checking for function. [. . . ]