User manual SEVERIN KS 9789

[. . . ] Dear Customer, Before using the appliance, please read the following instructions carefully and keep this manual for future reference. The appliance must only be used by persons familiar with these instructions. Connection to the mains supply The appliance should only be connected to an earthed socket installed in accordance with the regulations. Make sure that the supply voltage corresponds with the voltage marked on the rating label. [. . . ] Installation The appliance should be set up in a well-ventilated, dry room. It should be operated in conditions where the relative humidity is no more than 70 %. The product data sheet at the end of this manual contains Details of the ambient temperature range suitable for this appliance. Ensure that the plug is accessible and can be removed from the wall socket at any time. Do not expose the appliance to direct sunlight, and do not position it next to any heat sources (radiators, cookers etc. If this cannot be avoided, however, suitable insulation must be in installed between the heat source and the unit. The unit must not be installed inside a cabinet, nor directly below a hanging cupboard, shelf or similar object. In the case of uneven floors, the adjustable feet on the unit can be used to compensate and ensure optimum stability. set-up dimensions If the refrigerator is installed with its side against a wall, ensure a minimum clearance of 60 mm to ensure that the door can open through 90°. To remove the fresh-storage compartment, the bottle rack must be taken out first. To avoid the risk of personal injury or damage to the unit, two people are needed to reverse the door. Warning: Always disconnect the unit from the mains before any maintenance or repair work is carried out. Before you get started, please note the following: Always ensure that the correct number of washers is used on all hinge bolts and screws. So that the doors can close tightly against the frame, take the Utmost care that they are properly aligned during re-assembly. Remove the four covers C from the housing and inside of The door Replace the covers and their extensions, turned through 180° , on the opposite side. Unscrew the hinge bolt on the inside of the door in the area Take off the refrigerator door. Turn the bracket 6 including the small plastic plate through 180° and replace it on the other side of the refrigerator, using the two screw holes adjacent to each other. Unscrew the hinge bolt 2, together with the washers, from the bracket 7, and fit it into the corresponding opening on the opposite side of the bracket 7. Place the refrigerator door onto the hinge bolt 2 on holding bracket 7. Take out the cover 10 from the lower panel 1 and replace it on the opposite side. Fit the handle on the opposite side, using the fixing screws to secure it. Push the sealing plugs (provided) into the now empty openings in the door and replace the covering caps on the screw heads. [. . . ] The following table lists possible malfunctions and their probable causes and solutions. In the event of operational problems, check first whether a solution can be found using this table. If the problem persists, disconnect the appliance from the mains power and contact our Customer Service Department. To enable the melt-water to drain freely, always ensure that the channel and discharge opening in the cabinet are free of any blockage. [. . . ]