User manual SEVERIN KB 8876

DON'T FORGET : ALWAYS READ THE USER GUIDE BEFORE BUYING !!!

If this document matches the user guide, instructions manual or user manual, feature sets, schematics you are looking for, download it now. Diplodocs provides you a fast and easy access to the user manual SEVERIN KB 8876. We hope that this SEVERIN KB 8876 user guide will be useful to you.


SEVERIN KB 8876 : Download the complete user guide (499 Ko)

Manual abstract: user guide SEVERIN KB 8876

Detailed instructions for use are in the User's Guide.

[. . . ] Gas with a high level of environmental Ensure, therefore, that None of the components of the Cooling circuit does occur, do not In the case that There is an open fire or any other Sources of ignition in the vicinity of the Removed immediately from this area And that the room is then thoroughly In the appliance enclosure or in the Warning: Do not damage the cooling Causes damage to the eyes; there is Warning: Do not use any external The methods recommended in this Warning: Do not operate any electrical appliances (e. Ice makers) inside the storage compartment that are not specifically permitted in these instructions. Before it is connected to the mains power, the unit must be thoroughly checked for transport damage, including its power cord. In the event of any such damage being found, the appliance must not be connected to the mains. [. . . ] When the unit is first switched on, a slight `new' smell may be noticed. Installation The appliance should be set up in a well-ventilated, dry room. It should be operated in conditions where the relative humidity is no more than 70 %. The product data sheet at the end of this manual Contains details of the ambient temperature range suitable for this appliance. Ensure that the plug is accessible and can be removed from the wall socket at any time. Do not expose the appliance to direct sunlight, and do not position it next to any heat sources (radiators, cookers etc). If this cannot be avoided, however, a suitable insulation must be in installed between the heat source and the unit. The unit must not be installed inside a cabinet, nor directly below a hanging cupboard, shelf or similar object . Do not place any objects on top of the unit, and do not otherwise cover it. If the floor is uneven, the height-adjustable feet at the front of the unit can be used to compensate and ensure optimum stability. Ventilation Ensure that there is enough space around the unit so that the air circulation round and behind it is not obstructed. Warning: Always disconnect the unit from the mains before any maintenance or repair work is carried out. Use a suitable socket spanner to remove the three Screws holding the upper hinge to the housing, and then lift off the hinge. Carefully lift up the door and place it on a soft surface to protect it from scratches. Remove the three blind covers for the hinge mounting holes on the opposite side and fit them in the corresponding place on the other side. Remove the two screws on the lower hinge plate and take the plate off. Remove the hinge-pin from the hinge plate, turn the plate through 180° and put back the hinge-pin. Install the hinge plate with the hinge pin facing up on the other side. ensure that the Hinge pin is inserted into the guide bushing (hole) on the lower part of the door. Ensure that the hinge pin is inserted into the guide bushing (hole) on the upper part of the door. Adjust the closed door to its proper position and tighten the screws of the upper and lower hinge plates. Put the unit back in its intended position and wait for about four hours before connecting it to the mains. [. . . ] The propellant in the isolation Cyclopentane Make sure the tubes of the cooling circuit don't get Guarantee This product is guaranteed against defects in materials and workmanship for a period of two years from the date of purchase. Under this guarantee the manufacturer undertakes to repair or replace any parts found to be defective, providing the product is returned to one of our authorised service centres. This guarantee is only valid if the appliance has been used in accordance with the instructions, and provided that it has not been modified, repaired or interfered with by any unauthorised person, or damaged through misuse. This guarantee naturally does not cover wear and tear, nor breakables such as glass and ceramic items, bulbs etc. [. . . ]

DISCLAIMER TO DOWNLOAD THE USER GUIDE SEVERIN KB 8876




Click on "Download the user Manual" at the end of this Contract if you accept its terms, the downloading of the manual SEVERIN KB 8876 will begin.

 

Copyright © 2015 - manualRetreiver - All Rights Reserved.
Designated trademarks and brands are the property of their respective owners.