User manual SEGA GAME SHOW

[. . . ] 1ST PRINTING MAY `04 www. sauservice. com ® Owner's Manual A Game of Skill SEGA AMUSEMENTS USA, INC. 999-2035 GAME CODE: GSM VISIT OUR WEBSITE! BEFORE USING THE PRODUCT, BE SURE TO READ THE FOLLOWING: To maintain the safety: To ensure the safe usage of the product, be sure to read the following before using the product. The following instructions are intended for the users, operators and the personnel in charge of the operation of the product. After carefully reading and sufficiently understanding the warning displays and cautions, handle the product appropriately. [. . . ] Places subject to direct sunlight, or places subject to high temperatures in the proximity of heating units, etc. Places filled with inflammable gas or vicinity of highly inflammable/volatile chemicals or hazardous matter. Vicinity of anti-disaster facilities such as fire exits and fire extinguishers. The operating (ambient) temperature range is from 5ºC to 30ºC. WARNING! LIMITATIONS OF USAGE REQUIREMENTS WARNING! Be sure to check the Electrical Specifications. Ensure that this product is compatible with the location's power supply, voltage and frequency requirements. A plate describing Electrical Specifications is attached to the product. Non-compliance with the Electrical Specifications can cause a fire and electric shock. This product requires the Breaker and Earth Mechanisms as part of the location facilities. Using them in a manner not independent can cause a fire and electric shock. Ensure that the indoor wiring for the power supply is rated at 5 A or higher (AC single phase 100 ~ 120 V area). Non-compliance with the Electrical Specifications can cause a fire and electric shock. Be sure to independently use the power supply equipped with the Earth Leakage Breaker. Using a power supply without the Earth Leakage Breaker can cause an outbreak of fire when earth leakage occurs. Putting many loads on one electrical outlet can cause generation of heat and a fire resulting from overload. When using an extension cord, ensure that the cord is rated at 5 A or higher (AC 100 ~ 120 V area). Using a cord rated lower than the specified rating can cause a fire and electric shock. 3 www. seuservice. com Operation Area WARNING! For the operation of this machine, secure a minimum area of 25. 5 in. In order to prevent injury resulting from the falling down accident during game play, be sure to secure the minimum area for operation. Be sure to provide sufficient space so as to allow this product's ventilation fan to function efficiently. To avoid machine malfunctioning and a fire, do not place any obstacles near the ventilation opening. SEGA shall not be held responsible for damage, compensation for damage to a third party, resulting from the failure to observe this instruction. STOP IMPORTANT! For transporting the machine into the location's building, the minimum necessary dimensions of the opening (of doors, etc. ) are 26 in. OPERATION PRECAUTIONS TO BE HEEDED BEFORE STARTING THE OPERATION To avoid injury and trouble, be sure to constantly give careful attention to the behavior and manner of the visitors and players. In order to avoid accidents, check the following before starting the operation: WARNING! To ensure maximum safety for the players and the customers, ensure that where the product is operated has sufficient lighting to allow any warnings to be read. Operation under insufficient lighting can cause bodily contact with each other, hitting accident, and or trouble between customers. [. . . ] The operator turns off the power to the game, sets this setting and returns the power which resets the game and clears any unpaid prizes. The operator then turns the power off, returns the setting to `Normal' and resumes play. Game Test The game is tested simply by opening the door and actuating the door switch located at the upper right hand corner of the insice of the playfield door. Depressing this switch and holding it in emulates a `door closed' condition. The game is designed to, upon `door closed' after filling stock, etc. , run the auger motor, run the superball motor, cycle the displays, flash the playfield lamps, and draw back the ball release plunger in order to insure each of these devices are working. [. . . ]