User manual SEGA DREAMCAST HARDWARE BROADBAND ADAPTER

[. . . ] If at some point in time you wish to play a network game or application that only supports the use of the modem just reverse the procedure described below to reinstall it. 1 Remove the modem Modem Be sure to turn the power off and disconnect the power cable first!Latch First, it is necessary to remove the modem that is installed in the Dreamcast. Begin by turning off the power, disconnecting the power cable and phone cable (if connected) and then turn the Dreamcast on its side as shown in the illustration above so that the modem is on top. [. . . ] Dust on the connectors could result in incorrect operation due to a poor connection. [Miscellaneous] q After opening the transparent pack that the Broadband Adapter is packaged in, dispose of the pack. Operation is subject to the following two conditions: (1) this device may not cause harmful interference (2) this device must accept any inter ference that may be received, including interference that may cause undesired operation. Once the modem has been removed, refer to the diagram and insert the Broadband Adapter. Press firmly on the Broadband Adapter until it snaps into place and its edges are flush with the Dreamcast. 3 Plug in the Ethernet cable q After the Broadband Adapter is installed, an Ethernet cable (purchased separately) must be connected. Refer to About the Ethernet Cable for details about the type of cable to use. q Ensure the orientation of the connector is correct and then insert the Ethernet cable connector into Broadband Adapter until it clicks into place. Ethernet cable 4 Installation complete Installation of the Broadband Adapter is complete. Connect a Dreamcast controller, and other peripheral devices as desired, and the power cable. To use the Broadband Adapter, place a Broadband Adapter supporting game or application into the Dreamcast and turn the power on. Please refer to the game or application users manual for specific details about network connection and operation. BAdapter_MA 1/11/01 12:07 PM Page 2 About the Broadband Adapter Although the Broadband Adapter and the modem are identical in shape when viewed from the side, the cable connectors are different. In addition, the cable connector on the modem is labeled "LINE", while the cable connector on the Broadband Adapter is labeled "LAN". Troubleshooting Before contacting Sega or requesting service, please check the following: 1. Is the Ethernet cable firmly connected to both the Dreamcast and your Ethernet equipment?Is the Broadband Adapter correctly and securely connected to the Dreamcast?The Broadband Adapter can only be used with software that supports its use. Is the Ethernet cable the correct configuration for both the Broadband Adapter and the Ethernet equipment you are using? [. . . ] · Unauthorized reproduction of the contents of this document is prohibited. · SEGA, Dreamcast and the Dreamcast logo are either registered trademarks or trademarks of Sega Corporation. Export, use for profit, rental or leasing of this product is prohibited. [. . . ]