User manual SEGA CASH CUBE CLUB KART PRIZE

[. . . ] RND-0050 REV 1 SERVICE MANUAL CASH CUBE Before using this product, read this SERVICE MANUAL carefully to understand the contents stated herein. After reading this manual, be sure to keep it available nearby the product or somewhere convenient in order to be able to refer to it whenever necessary. Manufactured in the UK by CONTENTS BEFORE USING THIS PRODUCT . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 3 INSPECTIONS IMMEDIATELY AFTER TRANSPORTING THE PRODUCT TO THE LOCATION 4 2. [. . . ] Faulty Hopper or Hopper drive PCB Faulty Hopper internal or external loom Check connectors. HOPPER ASSEMBLY The machine uses a Coin Controls 24V DC hopper assembly. 3. 12. 1. HOPPER OPERATION Each disc contains a number of holes in which coins are held in short stacks. As the disc rotates, the coin at the bottom of one of the stacks will make contact with the ejector fingers and start to push the fingers back. Further rotation of the disc will cause the coin to start to move outwards into the exit slot. At this point the spring will be free to pull the ejector fingers forward and push the coin through the exit slot. The infrared light beam is routed across the exit slot via a light guide. When coin passes through the exit the light beam will be broken and coin output signal will be generated. The hopper will automatically brake when power is interrupted, or machine placed in the off state, thus preventing overrun and excessive coin payout. An over current detection circuit reverses the hopper momentarily in the event of a coin jam, and then attempts to continue payout. This oscillation of the disc will continue until either the coins are freed, the hopper is switched off, or the overload trip switches. Should the latter occur the hopper supply must be disconnected, the fault condition must be corrected and the trip be allowed time to cool (Approx. 30 seconds) before the hopper will start. 3. 12. 2. HOPPER ASSEMBLY FAULT FINDING Coins fail to unjam 1. Detach the metalwork surrounding the hopper by removing the 2 screws and 3 nuts that hold it in place. Rotating the disc manually first anti-clockwise then clockwise to free the coin. Do not return damaged coins to bowl. OR Remove any debris from the disc bed assembly. Hopper over-current protective device tripped (Wait 30 seconds while supply off). Over payout of coins 1. Poor connection (check common return wires) to hopper. 30 Dismantling the Hopper 1. Slide the bowl forward until the locating lugs, at the front of the bowl, are clear of the slots in the base. Connect the cable to the motor assembly, ensuring that the 4-pin connector is the correct way round. Lower the motor assembly into the base, ensuring that the coin exit is in the rear exit position. Locate the lugs, on the front of the bowl, into the slots at the front of the base. Gently press down until the securing clips, on the base, click into the slots in the bowl. Routine cleaning: All accessible parts of the coin route should be cleaned periodically using a mild detergent on a damp cloth. [. . . ] This histogram should be referred to when setting the game difficulty. 71 Pressing the TEST Button will bring up the following screen. <For POUND Setting> BOOKKEEPING 3/4 Screen -------------------------------------------BOOKKEEPING 3/4 COIN IN COIN IN COIN IN COIN IN COIN IN COIN IN ( 0. 05) ( 0. 10) ( 0. 20) ( 0. 50) ( 1. 00) ( 2. 00) = = = = = = 0 0 0 0 0 0 = = = = 0. 00 0. 00 0. 00 0. 00 CASH IN CASH OUT ATTENDANT OUT SERVICE CREDITS PRESS TEST BUTTON TO CONTINUE -------------------------------------------Number of individual coins inserted. COIN IN: CASH IN: CASH OUT: ATTENDANT OUT: SERVICE CREDITS: Total monetary value inserted. Number of credits added with the SERVICE Button. Pressing the TEST Button will bring up the following screen. <For DOLLAR, EURO, or ANY CASH Settings> BOOKKEEPING 3/4 Screen -------------------------------------------BOOKKEEPING 3/4 COIN IN ( 0. 05) COIN IN ( 0. 10) COIN IN ( 0. 20) COIN IN ( 0. 25) COIN IN ( 0. 50) COIN IN ( 1. 00) COIN IN ( 2. 00) TOKEN IN ( 1. 00) TOTAL IN VALUE TOTAL OUT VALUE ATTENDANT OUT SERVICE CREDITS = = = = = = = = 0 0 0 0 0 0 0 0 = 0. 00 = 0. 00 = 0. 00 = 0. 00 PRESS TEST BUTTON TO CONTINUE -------------------------------------------- 72 COIN IN: TOKEN IN: TOTAL IN VALUE: TOTAL OUT VALUE: ATTENDANT OUT: SERVICE CREDITS: Number of individual coins inserted. Number of credits added with the SERVICE Button. Pressing the TEST Button will bring up the following screen. BOOKKEEPING 4/4 Screen -------------------------------------------BOOKKEEPING 4/4 SETTINGS: DOSH DASH RACE: PAYOUT: 90% WINS / GAMES (WIN%) BEGINNER : 0/ 0 (0. 0%) TOTAL: INTERMEDIATE: 0/ 0 (0. 0%) BET: EXPER: 0/ 0 (0. 0%) WIN: WINMAX WINAVG TTLAVG BEGINNER: 0 0. 0 0. 0 D_D RACE: INTERMEDIATE: 0 0. 0 0. 0 BET: EXPERT: 0 0. 0 WIN: P/O DOUBLE UP CHALLENGE: GAMES: 0 DOUBLE UP: DONE: 0. 00% BET: MAX: 0 WIN: WIN. R: 0. 00% P/O: [ 0] 0 [ 1] 0 CONTINUE: [ 2] 0 BET: [ 3] 0 WIN: [ 4] 0 P/O: [ 5] 0 [ 6] 0 [ 7] 0 [ 8] 0 [ 9] 0 [10] 0 [11] 0 CONTINUE: TRY: 0 / 0 (0. 00%) WIN: 0 / 0 (0. 00%) PRESS TEST BUTTON TO EXIT -------------------------------------------- 73 SETTINGS: PAYOUT: TOTAL: BET: WIN: P/O: D_D RACE: BET: WIN: P/O: Payout ratio setting. Total number of bets made. [. . . ]