User manual SEB SENSEO VIVA

[. . . ] Do not interrupt the descaling cycle and do not switch off the machine before you have performed the two flushing cycles. The CALC light continues flash until the descaling procedure is completed correctly. For more information on why it is important to descale, when to descale and how to descale or which descaler to use, visit our website at www. Frost-free storage If you already used the coffee machine and have therefore already flushed it with water, you may only use and store it in a frost-free place to prevent it from becoming damaged. [. . . ] -- Never put normal ground coffee or use torn pods in the SENSEO® machine, as this causes it to become blocked. -- Do not use the machine in combination with a transformer, as this could cause hazardous situations. -- Do not place the appliance on a hotplate, directly next to a hot oven, heater or similar source of heat. -- Do not use the machine at altitudes higher than 2200 metres above sea level. -- Never pour any other liquid than clean cold water into the water reservoir. -- Never flush the machine or let it brew coffee when the spout is not in place. -- Flush the coffee machine with fresh water before you use it for the first time (see chapter ‘First use’). This causes the system to fill with water, which is essential for the machine to work properly. -- Do not use the SENSEO® machine in combination with water softeners based on sodium exchange. -- Philips strongly advises you to descale this SENSEO® regularly. If the machine is not descaled in time and according to the procedure described in chapter ‘Descaling’, this may lead to technical failures. -- After unpacking the machine, never put your SENSEO® machine on its side. Troubleshooting This chapter summarises the most common problems you could encounter with the machine. If you are unable to solve the problem with the information below, visit www. Com/support for a list of frequently asked questions or contact the Consumer Care Centre in your country. Achten Sie immer – auch beim Transport – darauf, dass sie senkrecht steht -- After unpacking the machine, never put your SENSEO® machine on its side. Solution You have pressed the 1-cup button and the 2-cup button at the same time. If you did not intend to start the descaling cycle, simply press the on/off button to switch off the machine. If you did intend to start the descaling cycle, do not interrupt this cycle but let the appliance operate until the water reservoir is empty. Make sure that there is enough water in the water reservoir and that the water reservoir is placed properly. Empty the water reservoir and shake it a few times to release the float. Clean the water reservoir with hot water and some washing-up liquid or in the dishwasher. [. . . ] Make sure the intensity switch on the front of the machine is in the right setting. When you adjust the switch, the volume in the cup is also adjusted (HD7833, HD7831 only). If you cannot clean it properly with the washing-up brush, put the pod holder in the machine and descale the machine (see chapter CALC). When I press the 1-cup or 2-cup button, the brewing briefly stops and then continues again. [. . . ]