User manual SEAGATE ST9500530NS REV D

[. . . ] Product Manual Constellation Serial ATA ® ST9500530NS ST9160511NS 100538694 Rev. D February 2011 Revision history Revision Date Sheets affected or comments Rev. February 2011 Seagate, Seagate Technology and the Wave logo are registered trademarks of Seagate Technology LLC in the United States and/or other countries. Momentus and SeaTools are either trademarks or registered trademarks of Seagate Technology LLC or one of its affiliated companies in the United States and/or other countries. [. . . ] Seagate uses an independent laboratory to confirm compliance with the EC directives specified in the previous paragraph. Although CE-marked Seagate drives comply with the directives when used in the test systems, we cannot guarantee that all systems will comply with the directives. The drive is designed for operation inside a properly designed enclosure, with properly shielded I/O cable (if necessary) and terminators on all unused I/O ports. Computer manufacturers and system integrators should confirm EMC compliance and provide CE marking for their products. 18 Constellation Serial ATA Product Manual, Rev. D Korean RRL If these drives have the Korea Ministry of Information and Communication (MIC) logo, they comply with paragraph 1 of Article 11 of the Electromagnetic Compatibility control Regulation and meet the Electromagnetic Compatibility (EMC) Framework requirements of the Radio Research Laboratory (RRL) Ministry of Information and Communication Republic of Korea. These drives have been tested and comply with the Electromagnetic Interference/Electromagnetic Susceptibility (EMI/EMS) for Class B products. Drives are tested in a representative, end-user system by a Korean-recognized lab. · Constellation Serial ATA · Certificate number: STX- ST9500530NS (B) Australian C-Tick (N176) If these models have the C-Tick marking, they comply with the Australia/New Zealand Standard AS/NZS3548 1995 and meet the Electromagnetic Compatibility (EMC) Framework requirements of the Australian Communication Authority (ACA). 3. 13. 3 FCC verification These drives are intended to be contained solely within a personal computer or similar enclosure (not attached as an external device). As such, each drive is considered to be a subassembly even when it is individually marketed to the customer. As a subassembly, no Federal Communications Commission verification or certification of the device is required. Seagate Technology LLC has tested this device in enclosures as described above to ensure that the total assembly (enclosure, disc drive, motherboard, power supply, etc. ) does comply with the limits for a Class B computing device, pursuant to Subpart J, Part 15 of the FCC rules. Operation with noncertified assemblies is likely to result in interference to radio and television reception. This equipment generates and uses radio frequency energy and if not installed and used in strict accordance with the manufacturer's instructions, may cause interference to radio and television reception. This equipment is designed to provide reasonable protection against such interference in a residential installation. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause interference to radio or television, which can be determined by turning the equipment on and off, you are encouraged to try one or more of the following corrective measures: · Reorient the receiving antenna. · Plug the computer into a different outlet so that the receiver and computer are on different branch outlets. If necessary, you should consult your dealer or an experienced radio/television technician for additional suggestions. You may find helpful the following booklet prepared by the Federal Communications Commission: How to Identify and Resolve Radio-Television Interference Problems. Refer to publication number 004-000-00345-4. Constellation Serial ATA Product Manual, Rev. D 19 3. 14 Environmental protection Seagate designs its products to meet environmental protection requirements worldwide, including regulations restricting certain chemical substances. [. . . ] ATA-reserved Security status Seagate-reserved ATA-reserved Integrity word Value Each drive will have a unique value. 0000H 0001H xxxxH 0000H xxA5H 112­127 128 129­159 160­254 255 Note. See the bit descriptions below for words 63, 84, and 88 of the Identify Drive data. Description (if bit is set to 1) Bit 0 1 2 8 9 10 Bit 0 1 2 3 4 5 6 7 8 9-10 11-12 13 14 15 Word 63 Multiword DMA mode 0 is supported. Shall be cleared to 0. Constellation Serial ATA Product Manual, Rev. D 31 Bit 0 1 2 3 4 5 6 8 9 10 11 12 13 14 Word 88 Ultra DMA mode 0 is supported. [. . . ]