User manual SEAGATE Q500 JUMPER SETTINGS
DON'T FORGET : ALWAYS READ THE USER GUIDE BEFORE BUYING !!!
If this document matches the user guide, instructions manual or user manual, feature sets, schematics you are looking for, download it now. Diplodocs provides you a fast and easy access to the user manual SEAGATE Q500. We hope that this SEAGATE Q500 user guide will be useful to you.
 |
SEAGATE Q500 JUMPER SETTINGS: Download the complete user guide (37 Ko) |
Manual abstract: user guide SEAGATE Q500JUMPER SETTINGS
Detailed instructions for use are in the User's Guide.
[. . . ] Q500
Jumper Settings
Drive Select Five jumpers are provided for logical number assignment. [. . . ] The drive select jumpers are located on the component side of the drive PCB. The PCB has various other jumper locations that are for factory use only. · Bios Settings The following CMOS parameters are provided for customers to configure the Quantum Q500 disk drive
1 of 1
Q500?
CMOS Q520 Q530 Q540
q500_jumper. pdf
Cylinders Heads Sectors Write Precomp Interleave
512 4 32 256 2:1
512 6 32 256 2:1
512 8 32 256 2:1
Special Considerations
??The Q500 series drive requires a ST506/412 controller board and a low-level format utility
provide by the controller manufacturer. [. . . ] If the Q500 disk drive is the last device on the interface cable a 220/330 ohm resistor pack
must be in place at location RN 3 on the PCB. [. . . ]
DISCLAIMER TO DOWNLOAD THE USER GUIDE SEAGATE Q500
Click on "Download the user Manual" at the end of this Contract if you accept its terms, the downloading of the manual SEAGATE Q500 will begin.