User manual SEAGATE FIREBALL SE JUMPER SETTINGS ATA

[. . . ] Fireball SE Jumper Settings ATA Jumper Settings DS Stand Alone Master with Slave Present Slave to Master ON ON OFF CS OFF OFF OFF PK X X X Rsvd OFF OFF OFF X = PK is a Parking position. [. . . ] Cylinders 2. 1 GB 3. 2 GB 4. 3 GB 6. 4 GB 8. 4 GB 4092 6256 14848 13328 16383 Heads 16 16 9 15 16 Sectors 63 63 63 63 63 Base 2 Capacity 2, 014 MB 3, 079 MB 4, 110 MB 6, 149 MB 8, 063 MB Base 10 Capacity 2, 111 MB 3, 228 MB 4, 310 MB 6, 448 MB 8, 455 MB Special Considerations Hard drives greater than 2. 1GB may need to be divided into multiple partitions / logical drives. MS-DOS versions 4. 0 through 6. 22 allow a maximum primary partition / logical drive size of 2. 1GB and are limited to 8. 4GB in physical drive capacity. The file systems supported by Windows-95, Windows-98 and Windows NT are not restricted to the 8. 4GB physical drive limit, but special BIOS support is required. SCSI Jumper Settings The following describes the jumper options and settings available on the Fireball SE drive. For more detail on jumper definitions; please refer to the jumper definition section. Termination Enable (TE) Enable termination Disable termination TE jumper on TE jumper off SCSI ID (A2, A1, A0) Set drive SCSI ID See ID settings table below Park (PK) Used for spare jumper N/A Jumper Locations The Fireball SE disk drive has only one location where user configurable jumpers are found. The jumper block for the Fireball SE is found on the disk drive printed circuit board. [. . . ] Drive ID ID 0 ID 1 ID 2 ID 3 ID 4 ID 5 ID 6 ID 7 A0 OFF ON OFF ON OFF ON OFF ON A1 OFF OFF ON ON OFF OFF ON ON A2 OFF OFF OFF OFF ON ON ON ON 3 of 3 [. . . ]