User manual SEAGATE BARRACUDA ES

[. . . ] Product Manual Barracuda ES Serial ATA ST3750640NS ST3500630NS ST3400620NS ST3250620NS ST3320620NS ST3750840NS ST3500830NS ST3400820NS ST3250820NS ST3320820NS 100424667 Rev. D September 2007 Revision history Revision Date Sheets affected or comments Rev. D September 2007 Seagate, Seagate Technology and the Wave logo are registered trademarks of Seagate Technology LLC in the United States and/or other countries. Barracuda, SeaTools and SeaTDD are either trademarks or registered trademarks of Seagate Technology LLC or one of its affiliated companies in the United States and/or other countries. [. . . ] D 2. 9. 6 Vibration All vibration specifications assume that the drive is mounted securely with the input vibration applied at the drive mounting screws. 2. 9. 6. 1 Operating vibration The maximum vibration levels that the drive may experience while meeting the performance standards specified in this document are specified below. 5­22 Hz 22­350 Hz 350­500 Hz 0. 25 Gs (Limited displacement) 0. 50 Gs 0. 25 Gs 2. 9. 6. 2 Nonoperating vibration The maximum nonoperating vibration levels that the drive may experience without incurring physical damage or degradation in performance when subsequently put into operation are specified below. 5­22 Hz 22­350 Hz 350­500 Hz 0. 25 Gs (limited displacement) 5. 0 Gs 1. 0 Gs 2. 10 Acoustics Drive acoustics are measured as overall A-weighted acoustic sound power levels (no pure tones). Sound power measurements are taken under essentially free-field conditions over a reflecting plane. The number of seeks per second is defined by the following equation: (Number of seeks per second = 0. 4 / (average latency + average access time) Table 7: Fluid Dynamic Bearing (FDB) motor acoustics Idle* Performance seek 3. 2 bels (typ) 3. 9 bels (max) 3. 2 bels (typ) 3. 5 bels (max) 3. 2 bels (typ) 3. 5 bels (max) 3. 2 bels (typ) 3. 5 bels (max) ST3750640NS, ST3750840NS ST3500630NS, ST3500830NS ST3400620NS, ST3400820NS ST3320620NS, ST3320820NS ST3250620NS, ST3250820NS 2. 7 bels (typ) 3. 0 bels (max) 2. 5 bels (typ) 2. 8 bels (max) 2. 5 bels (typ) 2. 8 bels (max) 2. 5 bels (typ) 2. 8 bels (max) *During periods of drive idle, some offline activity may occur according to the S. M. A. R. T. specification, which may increase acoustic and power to operational levels. Barracuda ES Serial ATA Product Manual, Rev. D 21 2. 11 Electromagnetic immunity When properly installed in a representative host system, the drive operates without errors or degradation in performance when subjected to the radio frequency (RF) environments defined in the following table: Table 8: Test Electrostatic discharge Radiated RF immunity Electrical fast transient Surge immunity Conducted RF immunity Voltage dips, interrupts Radio frequency environments Description Contact, HCP, VCP: ± 4 kV; Air: ± 8 kV 80 to 1, 000 MHz, 3 V/m, 80% AM with 1 kHz sine 900 MHz, 3 V/m, 50% pulse modulation @ 200 Hz ± 1 kV on AC mains, ± 0. 5 kV on external I/O ± 1 kV differential, ± 2 kV common, AC mains Performance level B A Reference standard EN 61000-4-2: 95 EN 61000-4-3: 96 ENV 50204: 95 EN 61000-4-4: 95 EN 61000-4-5: 95 EN 61000-4-6: 97 EN 61000-4-11: 94 B B 150 kHz to 80 MHz, 3 Vrms, 80% AM with 1 kHz sine A 0% open, 5 seconds 0% short, 5 seconds 40%, 0. 10 seconds 70%, 0. 01 seconds C C C B 22 Barracuda ES Serial ATA Product Manual, Rev. D 2. 12 2. 12. 1 Reliability Annualized Failure Rate (AFR) and Mean Time Between Failures (MTBF) The product shall achieve an Annualized Failure Rate (AFR) of 0. 73% (MTBF of 1. 2 million hours) when operated in an environment that ensures the HDA case temperatures do not exceed 40°C. Operation at case temperatures outside the specifications in Section 2. 9 may increase the product AFR (decrease MTBF). AFR and MTBF are population statistics that are not relevant to individual units. AFR and MTBF specifications are based on the following assumptions for business critical storage system environments: · 8, 760 power-on-hours per year. · Systems will provide adequate cooling to ensure the case temperatures do not exceed 40°C. Temperatures outside the specifications in Section 2. 9 will increase the product AFR and decrease MTBF. Nonrecoverable read errors Annualized Failure Rate (AFR) Contact start-stop cycles Warranty 1 per 1015 bits read, max 0. 73% (nominal power, 40°C ambient temperature) 50, 000 cycles (at nominal voltage and temperature, with 60 cycles per hour and a 50% duty cycle) 5 years on distribution units. To determine the warranty for a specific drive, use a web browser to access the following web page: www. seagate. com/support/service/ From this page, click on the "Verify Your Warranty" link. You will be asked to provide the drive serial number, model number (or part number) and country of purchase. None required. Preventive maintenance 2. 13 2. 13. 1 Agency certification Safety certification The drives are recognized in accordance with UL 1950 and CSA C22. 2 (950) and meet all applicable sections of IEC950 and EN 60950 as tested by TUV North America. 2. 13. 2 Electromagnetic compatibility Hard drives that display the CE mark comply with the European Union (EU) requirements specified in the Electromagnetic Compatibility Directive (89/336/EEC). Testing is performed to the levels specified by the product standards for Information Technology Equipment (ITE). Emission levels are defined by EN 55022, Class B and the immunity levels are defined by EN 55024. Seagate uses an independent laboratory to confirm compliance with the EC directives specified in the previous paragraph. Although CE-marked Seagate drives comply with the directives when used in the test systems, we cannot guarantee that all systems will comply with the directives. The drive is designed for operation inside a properly designed enclosure, with properly shielded I/O cable (if necessary) and terminators on all unused I/O ports. Computer manufacturers and system integrators should confirm EMC compliance and provide CE marking for their products. Barracuda ES Serial ATA Product Manual, Rev. [. . . ] D 5. 0 Seagate Technology support services Online services Internet For information regarding Seagate products and services, visit www. seagate. com. Worldwide support is available 24 hours daily by email for your questions. Presales Support: Presales@Seagate. com Technical Support: DiscSupport@Seagate. com Warranty Support: http://www. seagate. com/support/service/index. html mySeagate my. seagate. com is the industry's first Web portal designed specifically for OEMs and distributors. It provides self-service access to critical applications, personalized content and the tools that allow our partners to manage their Seagate account functions. [. . . ]