User manual SCHOLTES TV 644 P GH

[. . . ] This unit may be installed and used only in permanently ventilated rooms in accordance with British Standard Codes Of Practice: B. The following requirements must be observed: · The room must be equipped with an air extraction system that expels any combustion fumes. This may consist of a hood or an electric fan that automatically starts each time the appliance is switched on. The installation cavity should have the dimensions indicated in the figure. [. . . ] These pipes must be installed so that they are never longer than 2000 mm when fully extended. Once connection has been carried out, make sure that the flexible metal pipe does not touch any moving parts and is not compressed. Only use pipes and seals that comply with current national regulations. When the installation process is complete, check the pipe fittings for leaks using a soapy solution. Should the gas pressure used be different (or vary slightly) from the recommended pressure, a suitable pressure regulator must be fitted to the inlet pipe (in order to comply with current national regulations). 78 MJ/m³ S R S R S S A A A TG 644 P GH TV 644 P GH TG 755 P GH TG 755 P XX TV 755 P GH 14 Description of the appliance Overall view GB Support Grid for COOKWARE GAS BURNERS Control Knobs for GAS BURNERS Support Grid for COOKWARE GAS BURNERS Control Knobs for GAS BURNERS Ignition for GAS BURNERS SAFETY DEVICES !Use the diameter of the cookware to choose the most appropriate burner to cook with. SAFETY DEVICE stops the gas flow if the flame is accidentally extinguished. In this case, the overlapping of the spokes will be clearly evident and the grid will not be aligned (see picture). The position of the corresponding gas burner or electric hotplate* is shown on every knob. Gas burners Each burner can be adjusted to one of the following settings using the corresponding control knob: · Off Maximum Minimum To turn on one of the burners, place a lighted match or lighter near the burner, press the knob all the way in and turn it anti-clockwise to the "High" setting. The knob must be pressed in for about 6 seconds until the device that keeps the flame lit warms up. Some models are equipped with an ignition button incorporated into the control knob. To light a burner, simply press the corresponding knob all the way in and then turn it anti-clockwise to the "High" setting, keeping it pressed in until the burner lights. If a flame is accidentally extinguished, turn off the control knob and wait for at least 1 minute before trying to relight it. To switch off the burner, turn the knob in a clockwise direction until it stops (when reaches the "· " position). Burner Fast (R) Semi Fast (S) Auxiliary (A) Ø Cookware Diameter (cm) 24 - 26 16 - 20 10 - 14 Practical advice on using the burners To ensure the burners operate efficiently: · Use appropriate cookware for each burner (see table) so that the flames do not extend beyond the bottom of the cookware. When the contents of the pan reach boiling point, turn the knob to minimum. GB To identify the type of burner, refer to the designs in the section entitled, "Burner and Nozzle Specifications". Make sure the pans do not overlap the edges of the hob while it is being used. DATA PLATE Electrical see data plate connections This appliance conforms to the following European Economic Community directives: - 2006/95/EEC dated 12/12/06 (Low Voltage) and subsequent amendments - 2004/108/EEC dated 15/12/04 (Electromagnetic Compatibility) and subsequent amendments - 93/68/EEC dated 22/07/93 and subsequent amendments. This appliance has been designed and manufactured in compliance with international safety standards. [. . . ] GB Problem The burner does not light or the flame is not even around the burner. possible causes/Solution · The gas holes on the burner are clogged. All the movable parts that make up the burner are mounted correctly. You keep the knob pressed in long enough to activate the safety device. [. . . ]