User manual SCHOLTES TRC 630 C

[. . . ] The appliance must be installed on a perfectly level Single-phase connection The hob is equipped with a pre-connected electricity supply cable, which is designed for single-phase connection. Connect the wires in accordance with the instructions given in the following table and diagrams: Voltage and mains frequency 220-240V 1+N ~ 50/60 Hz Electrical cable Wire connection : yellow/green; N: the two blue wires together L: brown and black together The thickness of the supporting surface should be taken into account when choosing the length of the screws for the fixing hooks: 30 mm thick: 17. Use short flat-bottomed screws to fix the 4 alignment springs in the holes provided at the central point of each side of the hob. Place the hob in the cavity, make sure it is in a central position and push down on the whole perimeter until the hob is stuck to the supporting surface. [. . . ] Period of time, the display scrolls quickly though the power levels and timer minutes. Each cooking zone is controlled using a selector button and a power adjustment device All the cooking zones may be programmed simultaneously, for a duration between 1 and 99 minutes. To begin operating a cooking zone, press the corresponding control button and set the desired power level (between 0 and 9) using the buttons The power function for the cooking zones may be used to shorten heating-up times. The display, the power level indicator, will alternately show the letter P and the power level set previously until the desired power level has been reached. Once this level has been reached, the display will revert to showing the set power level. To deactivate this function, press and hold for at least 2 seconds - the selector button corresponding to the cooking zone on which the using the buttons function has been activated; alternatively, select a different power level A buzzer sounds for approximately 1 minute and the cooking zone switches off when the set programme has finished. Using multiple programmes and the display If one or more hotplates are programmed, the display will show the data for the hotplate with the least time remaining, and the light corresponding to the position of the hotplate will flash. The lights corresponding to the other hotplates programmed will be switched on. The times remaining for each hotplate will be shown in a clockwise order, beginning with the front left hotplate. Use the button repeatedly until the duration buttons to set the new duration. If the control panel lock has been activated, the controls will continue to be locked even after the hob is switched on again. In order to switch the hob on again, you must first remove the lock function. It is possible to set the hob to a demonstration mode where all the controls work normally but the heating elements do not switch on. To activate the demo mode the hob must be switched on, with all the hotplates switched off. At step 2, press the duration decreases progressively until it reaches 0 and switches off. Press the programming button until the timer indicator light is illuminated. Practical advice on using the appliance To obtain the best results from your hob: Use pans with a thick, flat base in order to fully utilise the cooking zone. When the hob is switched on, it is possible to lock the oven controls in order to avoid accidental changes being made to the settings (by children, during cleaning, etc. Press the button to lock the control panel: the indicator light above the button will switch on. Press the button for a few moments, the indicator light will switch off and the lock function will be removed. Always use pans with a diameter which is large enough to cover the hotplate fully, in order to use all the available heat. Make sure that the base of the cookware is always clean and dry, in order to fully utilise and extend the life of both the cooking zones and the cookware. [. . . ] If the hob is particularly dirty, rub it with a special glass ceramic cleaning product, then rinse well and dry thoroughly. Remove spills as soon as possible, without waiting for the appliance to cool, to avoid residues forming crusty deposits. You can obtain excellent results by using a rust-proof steel wire sponge - specifically designed for glass ceramic surfaces - soaked in soapy water. If any plastic or sugary substances are accidentally melted on the hob, remove them immediately with the scraper, while the surface is still hot. [. . . ]