User manual SCHOLTES TIP 733 TOL

[. . . ] Pour permettre une bonne aération et pour éviter toute surchauffe des surfaces autour de lappareil, la table de cuisson doit être positionnée : à au moins 40 mm de distance du mur arrière ou de toute autre surface verticale; de manière à ce quil reste au moins 20 mm de distance entre la découpe dencastrement et le meuble en dessous. Switching on the hob Switching on the cooking zones Medium function Booster function Switching off the cooking zones Programming the cooking duration Timer Control panel lock Switching off the hob Demo mode Practical advice on using the appliance Safety devices Practical cooking advice General safety Disposal Please keep these operating instructions for future reference. Before operating your new appliance please read this The appliance must be installed by a qualified professional in accordance with the instructions provided. Incorrect installation may cause harm to people and animals or may damage property. [. . . ] The types of noise listed above are due to induction technology and are not necessarily operational faults. Seconds: the cooking zone will immediately begin operating at its maximum power level (16). The booster function for some of the cooking zones may be used to shorten heating-up times. This function boosts the power to 2000 W or 3000 W, depending on the size of the corresponding cooking zone. While the booster for one of the cooking zones is active, the corresponding front or rear cooking zone will operate at a reduced power level (e. If the booster for the rear left-hand hotplate has been activated, the power level of the front left-hand hotplate will be reduced). To switch off a cooking zone: Press the progressively decrease until it is switched off. Alternatively, the simultaneously: this immediately returns the power setting to 0 and the cooking zone switches off. Period of time, the timer scrolls quickly through the minute values in the corresponding direction. When the hob is switched on, it is possible to lock the oven controls in order to avoid accidental changes being made to the settings (by children, during cleaning, etc. Press the button to lock the control panel: the indicator light above the button will switch on. Press the button for a few moments, the indicator light will switch off and the lock function will be removed. A buzzer sounds for approximately 1 minute and the cooking zone switches off when the set programme has finished. Using multiple programmes and the display If one or more hotplates are programmed, the display will show the data for the hotplate with the least time remaining, and the light corresponding to the position of the hotplate will flash. The lights corresponding to the other hotplates programmed will be switched on. to display the time remaining for the other programmed hotplates , press the button repeatedly. The times remaining for each hotplate will be shown in a clockwise order, beginning with the front left hotplate. Use the button repeatedly until the duration you buttons to set the new duration. If the control panel lock has been activated, the controls will continue to be locked even after the hob is switched on again. In order to switch the hob on again, you must first remove the lock function. It is possible to set the hob to a demonstration mode where all the controls work normally but the heating elements do not switch on. To activate the demo mode the hob must be switched on, with all the hotplates switched off. [. . . ] To avoid any interference between your induction hob and a pacemaker, the latter must be designed to comply with relevant regulations. Please consult the pacemaker manufacturer or your doctor concerning its conformity or any possible incompatibility. When disposing of packaging material: observe local legislation so that the packaging may be reused. The European Directive 2002/96/EC relating to Waste Electrical and Electronic Equipment (WEEE) states that household appliances should not be disposed of using the normal solid urban waste cycle. [. . . ]