User manual SCHOLTES TIP 642 DD L

[. . . ] Any deformities caused by improper fixing could affect the features and operation of the hob. The thickness of the supporting surface should be taken into account when choosing the length of the screws for the fixing hooks: 30 mm thick: 23 mm screws 40 mm thick: 13 mm screws . Use short flat-bottomed screws to fix the 4 alignment springs in the holes provided at the central point of each side of the hob. Place the hob in the cavity, make sure it is in a central position and push down on the whole perimeter until the hob is stuck to the supporting surface. [. . . ] The booster function for some of the cooking zones may be used to shorten heating-up times. This function boosts the power to 2000 W or 3000 W, depending on the size of the corresponding cooking zone. While the booster for one of the cooking zones is active, the corresponding front or rear cooking zone will operate at a reduced power level (e. If the booster for the rear left-hand hotplate has been activated, the power level of the front left-hand hotplate will be reduced). To switch off a cooking zone: Press the progressively decrease until it is switched off. Alternatively, the simultaneously: this immediately returns the power setting to 0 and the cooking zone switches off. Period of time, the timer scrolls quickly through the minute values in the corresponding direction. When the hob is switched on, it is possible to lock the oven controls in order to avoid accidental changes being made to the settings (by children, during cleaning, etc. Press the button to lock the control panel: the indicator light above the button will switch on. Press the button for a few moments, the indicator light will switch off and the lock function will be removed. A buzzer sounds for approximately 1 minute and the cooking zone switches off when the set programme has finished. Using multiple programmes and the display If one or more hotplates are programmed, the display will show the data for the hotplate with the least time remaining, and the light corresponding to the position of the hotplate will flash. The lights corresponding to the other hotplates programmed will be switched on. to display the time remaining for the other programmed hotplates , press the button repeatedly. The times remaining for each hotplate will be shown in a clockwise order, beginning with the front left hotplate. Use the button repeatedly until the duration you buttons to set the new duration. If the control panel lock has been activated, the controls will continue to be locked even after the hob is switched on again. In order to switch the hob on again, you must first remove the lock function. It is possible to set the hob to a demonstration mode where all the controls work normally but the heating elements do not switch on. To activate the demo mode the hob must be switched on, with all the hotplates switched off. At step 2, press the button: the duration decreases progressively until it reaches 0 and switches off. Practical advice on using the appliance Use cookware made from materials which are compatible with the induction principle (ferromagnetic material). [. . . ] If the hob is particularly dirty, rub it with a special glass ceramic cleaning product, then rinse well and dry thoroughly. Remove spills as soon as possible, without waiting for the appliance to cool, to avoid residues forming crusty deposits. You can obtain excellent results by using a rust-proof steel wire sponge - specifically designed for glass ceramic surfaces - soaked in soapy water. If any plastic or sugary substances are accidentally melted on the hob, remove them immediately with the scraper, while the surface is still hot. [. . . ]