User manual SCHOLTES TIO 633 T L

[. . . ] The thickness of the supporting surface should be taken into account when choosing the length of the screws for the fixing hooks: 30 mm thick: 23 mm screws 40 mm thick: 13 mm screws . Use short flat-bottomed screws to fix the 4 alignment springs in the holes provided at the central point of each side of the hob. Place the hob in the cavity, make sure it is in a central position and push down on the whole perimeter until the hob is stuck to the supporting surface. Or hobs with raised sides: After inserting the hob into its cavity, insert the 4 fixing hooks (each has its own pin) into the lower edges of the hob, using the long pointed screws to fix them in place, until the glass is stuck to the supporting surface. [. . . ] This function boosts the power to 2000 W or 3000 W, depending on the size of the relevant cooking zone. While the booster for one of the cooking zones is active, the corresponding front or rear cooking zone will operate at a reduced power level (e. If the booster for the rear left-hand hotplate has been activated, the power level of the front left-hand hotplate will be reduced). All the cooking zones may be programmed simultaneously, for a duration between 1 and 99 minutes. Period of time, the display scrolls quickly though the power levels and timer minutes. A buzzer sounds for approximately 1 minute and the cooking zone switches off when the set programme has finished. Using multiple programmes and the display If one or more hotplates are programmed, the display will show the data for the hotplate with the least time remaining, and the light corresponding to the position of the hotplate will flash. The lights corresponding to the other hotplates programmed will be switched on. to display the time remaining for the other programmed hotplates , press the button repeatedly. The times remaining for each hotplate will be shown in a clockwise order, beginning with the front left hotplate. Use the button repeatedly until the duration buttons to set the new duration. When the hob is switched on, it is possible to lock the oven controls in order to avoid accidental changes being made to the settings (by children, during cleaning, etc. Press the button to lock the control panel: the indicator light above the button will switch on. Press the button for a few moments, the indicator light will switch off and the lock function will be removed. If the control panel lock has been activated, the controls will continue to be locked even after the hob is switched on again. In order to switch the hob on again, you must first remove the lock function. It is possible to set the hob to a demonstration mode where all the controls work normally but the heating elements do not switch on. To activate the demo mode the hob must be switched on, with all the hotplates switched off. At step 2, press the duration decreases progressively until it reaches 0 and switches off. Press the programming button until the timer indicator light is illuminated. Practical advice on using the appliance Use cookware made from materials which are compatible with the induction principle (ferromagnetic material). We especially recommend pans made from: cast iron, coated steel or special stainless steel adapted for induction. [. . . ] If the hob is particularly dirty, rub it with a special glass ceramic cleaning product, then rinse well and dry thoroughly. Remove spills as soon as possible, without waiting for the appliance to cool, to avoid residues forming crusty deposits. You can achieve excellent results by using a rust-proof steel wire sponge - specifically designed for glass ceramic surfaces - soaked in soapy water. If any plastic or sugary substances are accidentally melted on the hob, remove them immediately with the scraper, while the surface is still hot. [. . . ]