User manual SCHOLTES TIC 642 DD L

[. . . ] The appliance must be installed on a perfectly level Other types of connection If the mains supply corresponds with one of the following: The thickness of the supporting surface should be taken into account when choosing the length of the screws for the fixing hooks: 30 mm thick: 23 mm screws 40 mm thick: 13 mm screws . Use short flat-bottomed screws to fix the 4 alignment springs in the holes provided at the central point of each side of the hob. Place the hob in the cavity, make sure it is in a central position and push down on the whole perimeter until the hob is stuck to the supporting surface. Or hobs with raised sides: After inserting the hob into its cavity, insert the 4 fixing hooks (each has its own pin) into the lower edges of the hob, using the long pointed screws to fix them in place, until the glass is stuck to the supporting surface. [. . . ] While the booster for one of the cooking zones is active, the corresponding front or rear cooking zone will operate at a reduced power level (e. If the booster for the rear left-hand hotplate has been activated, the power level of the front left-hand hotplate will be reduced). At step 2, press the duration decreases progressively until it reaches 0 and switches off. Press the programming button until the timer indicator light is illuminated. Practical advice on using the appliance Use cookware made from materials which are compatible with the induction principle (ferromagnetic material). We especially recommend pans made from: cast iron, coated steel or special stainless steel adapted for induction. When the hob is switched on, it is possible to lock the oven controls in order to avoid accidental changes being made to the settings (by children, during cleaning, etc. Press the button to lock the control panel: the indicator light above the button will switch on. Press the button for a few moments, the indicator light will switch off and the lock function will be removed. In addition, to obtain the best results from your hob: Use pans with a thick, flat base in order to fully utilise the cooking zone. Always use pans with a diameter which is large enough to cover the hotplate fully, in order to use all the available heat. If the control panel lock has been activated, the controls will continue to be locked even after the hob is switched on again. In order to switch the hob on again, you must first remove the lock function. It is possible to set the hob to a demonstration mode where all the controls work normally but the heating elements do not switch on. To activate the demo mode the hob must be switched on, with all the hotplates switched off. Make sure that the base of the cookware is always clean and dry, in order to fully utilise and extend the life of both the cooking zones and the cookware. Avoid using the same cookware which has been used on gas burners: the heat concentration on gas burners may distort the base of the pan, causing it not to adhere correctly. Safety switch The appliance has a safety switch which automatically switches the cooking zones off after they have been in operation for a certain amount of time at a particular power level. Or example: the right rear hotplate is set to 5 and will switch off after 5 hours of continuous operation, while the front left hotplate is set to 2 and will switch off after 8 hours. The hotplate only emits heat when a pan with suitable measurements for the cooking zone is placed on it. If the indicator light is flashing, it may indicate: An incompatible pan A pan whose diameter is too small The pan has been removed from the hotplate. Residual heat indicators Each cooking zone is equipped with a residual heat indicator. [. . . ] If the hob is particularly dirty, rub it with a special glass ceramic cleaning product, then rinse well and dry thoroughly. Remove spills as soon as possible, without waiting for the appliance to cool, to avoid residues forming crusty deposits. You can achieve excellent results by using a rust-proof steel wire sponge - specifically designed for glass ceramic surfaces - soaked in soapy water. If any plastic or sugary substances are accidentally melted on the hob, remove them immediately with the scraper, while the surface is still hot. [. . . ]