User manual SCHOLTES TI 6533

[. . . ] Separate the wires and connect them in accordance with the instructions given in the following table and diagrams: In order to adhere to safety standards, the Appliance must not come into contact with electrical parts once it has been installed. Connecting the electricity supply cable to the mains If the appliance is being connected directly to the electricity mains an omnipolar switch must be installed with a minimum opening of 3 mm between contacts. The installer must ensure that the correct electrical connection has been made and that it is fully compliant with safety regulations. All parts which ensure the safe operation of the Appliance must not be removable without the aid of a tool. [. . . ] A few seconds after the hob is connected to the The glue applied on the gaskets leaves traces of To switch off a cooking zone, select it using the corresponding selector button Press the and: All the cooking zones may be programmed simultaneously, for a duration between 1 and 99 minutes. Period of time, the display scrolls quickly though the power levels and timer minutes. Each cooking zone is controlled using a selector button and a power adjustment device To begin operating a cooking zone, press the corresponding control button and set the desired power level (between 0 and 9) using the buttons A buzzer sounds for approximately 1 minute and the cooking zone switches off when the set programme has finished. Using multiple programmes and the display If one or more hotplates are programmed, the display will show the data for the hotplate with the least time remaining, and the light corresponding to the position of the hotplate will flash. The lights corresponding to the other hotplates programmed will be switched on. to display the time remaining for the other programmed hotplates , press the button repeatedly. The times remaining for each hotplate will be shown in a clockwise order, beginning with the front left hotplate. Use the button repeatedly until the duration buttons to set the new duration. The booster function for some of the cooking zones may be used to shorten heating-up times. This function boosts the power to 2000 W or 3000 W, depending on the size of the relevant cooking zone. While the booster for one of the cooking zones is active, the corresponding front or rear cooking zone will operate at a reduced power level (e. It is possible, for example, to keep a dish warm or melt butter or chocolate. Overheating protection If the electronic elements overheat, the hob switches off automatically and followed by a flashing number. When the temperature has reached a suitable level, this message disappears and the hob may be used again. Buzzer This can also indicate several irregularities: An object (a pan, cutlery, etc. If the cause of the problem is not removed, the buzzer will keep sounding and the hob will switch off. Pressure cooking after whistle This appliance has been designed and manufactured in compliance with international safety standards. The following warnings are provided for safety reasons and must be read carefully. This appliance conforms to the following European Economic Community directives: - 2006/95/EEC dated 12/12/06 (Low Voltage) and subsequent amendments; - 2004/108/EEC dated 15/12/04 (Electromagnetic Compatibility) and subsequent amendments; - 93/68/EEC dated 22/07/93 and subsequent amendments. Make sure that the air inlet behind the fan grille is never obstructed. The built-in hob should, in fact, be provided with suitable ventilation for the cooling of the electronic components used in the appliance. We advise against the installation of an induction hob above an under-the-counter refrigerator (heat) or above a washing machine (vibrations). [. . . ] Some hobs have an aluminium frame which is Example, products in spray cans for cleaning barbecues and ovens), stain removers, anti-rust products, powder detergents or sponges with abrasive surfaces: these may scratch the surface beyond repair. Do not use any cleaning or degreasing products which are not suitable for use with aluminium. Never use steam cleaners or pressure cleaners on Loosen the screws holding the fixing hooks in each corner. It is usually sufficient simply to wash the hob using a damp sponge and dry it with absorbent kitchen towel. [. . . ]