User manual SCHOLTES TI 6514

[. . . ] ⷠAvoid installing the hob above a dishwasher: if this cannot be avoided, place a waterproof separation device between the two appliances. ⷠDepending on the hob you want to install, the cabinet must have the following dimensions (see figure): To allow adequate ventilation and to avoid overheating of the surrounding surfaces the hob should be positioned as follows: At a minimum distance of 40 mm from the back panel or any other vertical surfaces. ⷠSo that a minimum distance of 20 mm is maintained between the installation cavity and the cabinet underneath. ⷠKitchen cabinets adjacent to the appliance and taller than the top of the hob must be at least 600 mm from the edge of the hob. [. . . ] The min/med/max buttons can also be pressed directly to select the pre-set power levels: min (1) / med (8) / max (16), and to switch off the plate (see below). The booster function for some of the cooking zones may be used to shorten heating-up times. This function boosts the power to 2000 W or 3000 W, depending on the size of the corresponding cooking zone. While the booster for one of the cooking zones is active, the corresponding front or rear cooking zone will operate at a reduced power level (e. If the booster for the rear left-hand hotplate has been activated, the power level of the front left-hand hotplate will be reduced). To switch off the hotplate, select the button corresponding to the desired zone, moving the slider towards the left to return to level 0, or press the Off button on the slider control directly. The first time the slider is pressed, a short beep will sound to acknowledge the touch. If - and only if the power level is adjusted, another short beep will sound when the slider is released. The hotplate selection LEDs light up for the power adjustment period (10 seconds), during which the slider (or min/med/max buttons)* can influence the selected hotplate. To operate a cooking zone, select the button corresponding to the desired zone and set the required power level by pressing down on the slider and moving it towards the right to increase the Period of time, the timer scrolls quickly through the minute values in the corresponding direction. All the cooking zones may be programmed simultaneously, for a duration between 1 and 99 minutes. Make sure that the base of the cookware is always clean and dry, in order to fully utilise and extend the life of both the cooking zones and the cookware. ⷠAvoid using the same cookware which has been used on gas burners: the heat concentration on gas burners may distort the base of the pan, causing it not to adhere correctly. The hotplate only emits heat when a pan with suitable measurements for the cooking zone is placed on it. If the power level indicator display flashes, this may be because: · an incompatible pan · A pan whose diameter is too small · Buzzer This can also indicate several irregularities: · All of the above situations may cause the buzzer to sound. If the cause of the problem is not removed, the buzzer will keep sounding and the hob will switch off. When the temperature has reached a suitable level, this message disappears and the hob may be used again. the display will show the text DE and OF and the hob will be switched off. The EXTENSO TECHNOLOGY can be used to set the power of two "interconnected" hotplates to the same level. The following warnings are provided for safety reasons and must be read carefully. This appliance conforms to the following European Economic Community directives: - 2006/95/EEC dated 12/12/06 (Low Voltage) and subsequent amendments; - 2004/108/EEC dated 15/12/04 (Electromagnetic Compatibility) and subsequent amendments; - 93/68/EEC dated 22/07/93 and subsequent amendments. Make sure that the air inlet behind the fan grille is never obstructed. [. . . ] These individuals should, at the very least, be supervised by someone who assumes responsibility for their safety or receive preliminary instructions relating to the operation of the appliance. ⷠFor the attention of wearers of pacemakers or other active implants: The hob complies with all current standards on electromagnetic interference. Your induction hob is therefore perfectly in keeping with legal requirements (89/336/CEE directives). It is designed not to create interference on any other electrical apparatus being used on condition that the apparatus in question also complies with this legislation. [. . . ]