User manual SCHOLTES PPF 73 G

[. . . ] It is advisable to keep only the cylinder being used in the room, positioned so that it is not subject to heat produced by external sources (ovens, fireplaces, stoves, etc. ) which could raise the temperature of the cylinder above 50°C. The appliance must be installed by a qualified professional according to the instructions provided. Incorrect installation may cause harm to people and animals or may damage property. [. . . ] connecting the supply cable to the mains Install a standardised plug corresponding to the load indicated on the data plate. The appliance must be directly connected to the mains using an omnipolar circuit-breaker with a minimum contact opening of 3 mm installed between the appliance and the mains. The circuit-breaker must be suitable for the charge indicated and must comply with current electrical regulations (the earthing wire must not be interrupted by the circuitbreaker). The supply cable must not come into contact with surfaces with temperatures higher than 50°C. The installer must ensure that the correct electrical connection has been made and that it is compliant with safety regulations. Before connecting to the power supply, make sure that: · The socket can withstand the maximum power of the appliance, which is indicated on the data plate. If the socket is incompatible with the plug, ask an authorised technician to replace it. Once the appliance has been installed, the power supply cable and the electrical socket must be easily accessible. The cable must be checked regularly and replaced by authorised technicians only (see Assistance). The manufacturer declines any liability should these safety measures not be observed. The appliance should be connected to the main gas supply or to a gas cylinder in compliance with current national regulations. Once the adjustment has been made, replace the seals on the by-passes using sealing wax or a similar substance. The hob can only be installed above built-in ovens with a cooling ventilation system. Use the diameter of the cookware to choose the most appropriate burner to cook with. ⷠControl Knobs for GAS BURNERS adjust the power or the size of the flame. Each burner can be adjusted to one of the following settings using the corresponding control knob: 0 v Off Maximum Minimum To light one of the burners, hold a lit match or lighter near the burner and, at the same time, press down and turn the corresponding knob anti-clockwise to the maximum setting. Since the burner is fitted with a safety device, the knob should be pressed for approximately 2-3 seconds to allow the automatic device keeping the flame alight to heat up. When using models with an ignition button, light the desired burner pressing down the corresponding knob as far as possible and turning it anticlockwise towards the maximum setting. In this case, to activate it, simply start by turning the knob symbol, then press so that it is aligned with the it all the way in and hold it in this position for approximately 6 seconds, until the automatic device keeping the flame alight has heated up. If a flame is accidentally extinguished, turn off the control knob and wait for at least 1 minute before trying to relight it. To switch off the burner, turn the knob in a clockwise direction until it stops (when reaches the "0" position). The "separate double flame" burner* This burner consists of two concentric burners which can operate either together or separately. [. . . ] The following warnings are provided for safety reasons and must be read carefully. -Class 1: all models with edges that are higher than 58 mm (see overleaf, fig. -Class 3: all models with edges that are lower than 58 mm (see overleaf, fig. When installing the hob, follow the instructions provided in the paragraph on "Positioning" the appliance. [. . . ]