User manual SCHOLTES PP 40 TC F

[. . . ] Please keep this instruction booklet in a safe place for future reference. If the appliance is sold, given away or moved, please make sure the booklet is also passed on to the new owners so that they may benefit from the advice contained within it. The system can also provide the air needed for combustion indirectly, i. From adjacent rooms fitted with air circulation ducts as described above. [. . . ] Connection to the gas system must be carried out in such a way as not to place any strain of any kind on the appliance. There is an adjustable L-shaped pipe fitting on the appliance supply ramp and this is fitted with a seal in order to prevent leaks. The seal must always be replaced after rotating the pipe fitting (seal supplied with the appliance). These pipes must be installed so that they are never longer than 2000 mm when fully extended. Once connection has been carried out, make sure that the flexible metal pipe does not touch any moving parts and is not crushed. Only use pipes and seals that comply with the relevant current national regulations. When the installation process is complete, check the pipe fittings for leaks using a soapy solution. Adapting to different types of gas To adapt the hob to a different type of gas other than the default type (indicated by the label placed on the lower part of the hob or on the packaging), the burner nozzles should be replaced as follows: Unscrew the nozzles using a 7 mm socket spanner, and replace them with nozzles for the new type of gas (see table 1 "Burner and nozzle specifications"). Reassemble the parts, following the above procedure in the reverse order. Once this procedure is finished, replace the old rating sticker with one indicating the new type of gas used. The inner burner has one nozzle and the outer burner has two (these are the same size). Replace the nozzles with models which are suitable for use with the new type of gas (Table 1). Replace all the components by following the above instructions in reverse. Remove the knob and adjust the adjustment screw, which is positioned in or next to the tap pin, until the flame is small but steady. Having adjusted the flame to the required low setting, while the burner is alight, quickly change the position of the knob from minimum to maximum and vice versa several times, making sure that the flame is not extinguished. If the device fails to work when the burners are set to the low flame setting, increase this low flame setting using the adjustment screw. Once the adjustment has been made, replace the seals on the by-passes using sealing wax or a similar substance. Once this procedure is complete, replace the old rating sticker with one indicating the new type of gas used. If the gas pressure used is different (or varies slightly) from the recommended pressure, a suitable pressure regulator must be fitted to the inlet pipe (in order to comply with current national regulations relating to "regulators for channelled gas"). The hob can only be installed above built-in ovens with a cooling ventilation system. Select the most suitable burner in accordance with the diameter of the cookware you wish to use. Each burner can be adjusted to one of the following settings using the corresponding control knob: 0 Off Maximum Minimum To light one of the burners, hold a lit match or lighter near the burner and, at the same time, press down and turn the corresponding knob anti-clockwise until it reaches the maximum setting. [. . . ] The conditions relating to the adjustment procedure are listed on the label (or on the data plate); before installing the product, make sure the local supply conditions and the adjustment status are compatible. Intensive and prolonged operation of the appliance may require additional ventilation, for example a window should be opened or more efficient ventilation provided (the power of any mechanical ventilation system could be increased, for instance). The appliance is not intended to be operated by means of an external timer or separate remotecontrol system. When disposing of packaging material: observe local legislation so that the packaging may be reused. [. . . ]