User manual SCHOLTES MULTIPLO SF

[. . . ] Use the screws supplied to fit the 4 alignment springs in the holes provided at the central point of each side of the part underneath the hob. Place the hob in the cavity, make sure it is in a central position and push down on the whole perimeter until the hob is stuck to the supporting surface. ) All the necessary precautions must be taken in order to install the appliance in conformity with current accident-prevention regulations (CEI-UNI-CIG) relating to gas and electrical connections. To ensure sit-on hobs installed in kitchen cabinets operate correctly, the minimum distances indicated should be observed (see figure). [. . . ] When both hotplates have been programmed, the display will show the remaining time for whichever hotplate is selected; the position of this hotplate will be indicated by the activation of the corresponding indicator light. to display the time remaining for the programmed hotplate , press the or buttons. If both hotplates have been programmed to operate simultaneously, both cooking zone programmed indicator lights will switch on. Alternatively, activate the simultaneously; the power level will revert to 0 immediately and the cooking zone will switch off. The vertical position of the cooking recipient may be maintained until the cooking process is complete. Alternatively, once the correct boiling/frying temperature has been reached and the hotplate switched off using the relevant buttons, the cooking recipient may be rotated by 90°, returning it to a horizontal position on the front cooking zone and keeping the temperature constant (see figure). The free cooking zone may be used to start another cooking process using the power level using the When the hob is switched on, the oven controls may be locked in order to prevent the settings from being changed accidentally. Press the button to activate the function: the controls will be locked and the indicator light above the button will switch on. Press the button for a few moments, the indicator light will switch off and the lock function will be removed. The extreme flexibility and versatility of the Multiplo means it is possible to cook any type of dish quickly, without compromising its quality. The "Boost" function in particular speeds up cooking times for dishes such as pasta or any fried food, reducing the overall time required by approximately 50% in comparison with the time required when using a cooking recipient with a single cooking zone (horizontal position). To bring the water to the boil or to fry food quickly, simply switch on the hob, placing the single cooking recipient centrally and in a vertical position with respect to the text "boost" (see figure). If the appliance controls have been locked, they will continue to be locked even after the hob has been switched back on. In order to switch the hob on again, you must remove the lock function. The hotplate only emits heat when a cooking recipient is placed on it. If, once the appliance has been switched on and the cooking zone and corresponding power level selected, the numerical indicator flashes, this means that the cooking recipient should be placed in the corresponding position. Heat indicators If, after the appliance has been used, the letter H remains lit on the corresponding display, this means that the heating zone is still hot (temperature over 60°C); do not touch it. Buzzer This can also indicate several irregularities: Something has been spilt on the control panel. If the cause of the problem is not removed, the buzzer will keep sounding and the hob will switch off. Overheating protection The hob is fitted with a protection device for electronic components; in the event of overheating the power of the hotplates is limited automatically. Safety switch The appliance has a safety switch which automatically switches off the cooking zones when they have been in operation for a certain amount of time at a given power level. Or example: the rear hotplate is set to 5 and will switch off after 3 hours of continuous operation, while the front hotplate is set to 2 and will switch off after 10 hours. [. . . ] This maintenance task should be carried out while the appliance is warm (not hot) or cold. Always remember to rinse the appliance well with clean water and dry it thoroughly: residues can become encrusted during subsequent cooking processes. To prevent any burnt-on residue from building up Never use steam cleaners or pressure cleaners on Stainless steel can be marked by hard water which has been left on the surface for a long time, or by cleaning products containing phosphorus. After cleaning, it is advisable to rinse the surface well and dry it thoroughly. [. . . ]