User manual SCHOLTES B 20 L 2 VTC F

[. . . ] Switching off the cooking area The relevant cooking deve essere attivata ed il area must already be punto decimale activated with relative corrsopondente (12) deve decimal point (12) illuessere acceso; minated. Return the setting to "0" "0" mediante il tasto "-" by means of the key "-" (4). After three seconds, di cottura si spegna the cooking area will automaticamente; automatically switch off. The relevant cooking 1 ­ La zone de cuisson area must already be requise doit être activée activated with relaet le point décimal tive decimal point correspondant (12) doit (12) illuminated. [. . . ] The function uses maximum power to preheat the cooking area to bring it to the required operating temperature. After a time interval, the power level automatically returns to the original setting. Select power level 9 by means of key "+" (4), then press the "+" key (4) again to activate preheating. To preheat the unit with spontaneous movement towards the required power level (e. "6"), set the power to 6 by means of the "-" key (4). After the system has set to automatic preheating mode, the display panel will alternate the set power level ("6") and the automatic preheating function (indicated by the letter "A"). To deactivate the preheating function (indicated by the letter "A" on the display), press the "-" key (4) at least 10 seconds since the function has been activated. This function too simplifies operation by not requiring human supervision during the cooking cycle. Once the set time on the timer has elapsed, the cooking area is automatically switched off. The cooking area must already be activated with relative decimal point (12) illuminated. Press the timer key (6); the timer display shows "00" and the indicator (10) relative to the zone being programmed lights up. Select the cooking time (between 0 to 99 minutes) by means of the "+" and "-" keys (4). Press and hold down the "+" or "-" key (4) to scroll the time setting. Press the "+" and "-" keys (4) at the same time to shut down the relative cooking area immediately. When the timer function is not programmed, the timer display can be used simply to count down minutes (i. When the displayed time elapses, the cooking area is not deactivated). When the unit is off: Use the "+" and "-" minuteur (6) keys (4) to set the re3 ­ Régler le temps quired time to be voulu avec les touches counted back. When the unit is on and a cooking area is activated: Si le dispositif est allumé et une zone de cuisson est active : When the set time has elapsed, an acoustic signal is emitted for two minutes. Switching on two zones Press key (2/2) to switch on the central zone and the circular crown. Switching on three zones Press key (2/3) to switch on the central zone, the circular crown and the external half-crown. [. . . ] Should there be no cable and/or plug on the equipment, use suitable absorption material for the working temperature as well, as indicated on the matrix plate. If connecting directly to the mains power supply, fit a multi-pole switch of a suitable size for the rated capacity with a clearance distance which completely disconnects the power line under overvoltage category III conditions, consistently with the rules of installation (the yellow/green earth wir must not be interrupted). The plug or omnipolar switch must be easily reached on the installed equipment. The manufacturers decline any responsibility in the event of non-compliance with what is described above and the accident prevention norms not being respected and followed. [. . . ]