User manual SANYO VSE-2300HB

[. . . ] INSTRUCTION MANUAL VSE-2300 & VSE-2400 SERIES Cylindrical Environmental Camera Housings About this manual Before installing and using this unit, please read this manual carefully. Be sure to keep it available for later reference. IMPORTANT SAFEGUARDS 1. Read Instructions - All the safety and operating instructions should be read before the unit is operated. Retain Instructions - The safety and operating instructions should be retained for future reference. [. . . ] Cable Size: Outside diameter between 4. 6 mm (0. 181-in)­7. 9 mm (0. 312-in). Cable Size: Outside diameter between 4. 3 mm (0. 170 in)­11. 9 mm (0. 470 in). Use the two 1/4-20 x 0. 50-inch screws and 1/4-inch spring washers provided in the hardware kit to mount the housing to a mount or a pan/tilt. The outermost set of 1/4-20 threaded holes are for mounting to feed-through mounts and the innermost 1/420 holes are for mounting to all other mounts and pan/tilts. See Figure 1. Loosen These Screws Do Not Remove Figure 1: Loosening Captive Screws 2. See Figure 2. Grasp Here LENS CONTROL CABLE Cable Type: Jacketed multiconductor cable. Cable Size: Outside diameter between 4. 3 mm (0. 170 in)­11. 9 mm (0. 470 in). Allow the cover to dangle from the base. 6 6. 5 Camera/Lens Installation 1. Use the various 1/4-20 screws and spacers provided to mount the camera and the lens to the camera bracket. 6. 6 Camera/Lens Wiring WARNING: Only use the cables specified under "INSTALLATION, Cable Requirements" for wiring of all cameras and lenses. Camera Bracket Loosen These Screws 6. 6. 1 Fittings 1. The two large 1/2-inch NPT fittings accept round cable with diameters from 4. 3 mm (0. 17-inch) to 11. 9 mm (0. 47-inch). The small fittings will accept cables with diameters from 4. 6 mm (0. 181-inch) to 7. 9 mm (0. 312inch). Be sure to securely tighten all fittings to ensure a liquid-tight seal. Failure to do so could allow water to enter the housing and damage the camera and lens. Sealants that release acetic acid may harm camera electronics. Figure 3: Removing the Camera Bracket 2. If you are using the feed-through feature, refer to Section 6. 8. 3 at this time. Use the 1/4-20 x 3/8-inch screw to mount the camera to the camera bracket. The lens should extend approximately 6 mm (0. 25-inch) from the front of the camera bracket. See Figure 4. Use of "drip loops" is recommended on the wiring outside of the rear end cap. 6. 6. 2 Conduit These housings are designed to allow conduit to be directly connected. Remove the rear fittings and attach the conduit and conduit fittings directly to the housing rear cap. The holes accept 1/2-inch conduit fittings and PG 13. 5 conduit fittings. [. . . ] Be sure to securely tighten all fittings to ensure a liquid-tight seal. Failure to do so could allow water to enter the housing and damage the camera and lens. If using a pan/tilt with a feed-through cable, insert the camera/lens function cable in through the left fitting at the rear of the cradle. Use of "drip loops" is recommended on the wiring outside of the rear end cap. [. . . ]