User manual SANYO VDC-C1074VA

[. . . ] Be sure to keep it handy for later reference. L5QA2/US, US2, L5QB2/US, US2, L7QA2/US, US2 GB 2002, 4, 24 INFORMATION TO USER Safety Guard THIS SYMBOL INDICATES THAT THERE ARE IMPORTANT OPERATING AND MAINTENANCE INSTRUCTIONS IN THE LITERATURE ACCOMPANYING THIS UNIT. WARNING: TO PREVENT THE RISK OF FIRE OR ELECTRIC SHOCK , DO NOT EXPOSE THIS APPLIANCE TO RAIN OR MOISTURE UNLESS CLOSED AND SEALED. For customers in Canada This Class B digital apparatus complies with Canadian ICES-003. Pour la clientèle Canadienne Cet appareil numerique de la Classe B est conforme a la norme NMB-003 du Canada. This installation should be made by a qualified service person and should conform to all local codes. This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. [. . . ] If used with a foreign object inside, it could cause a fire, short-circuits or damages. If water or a liquid gets inside the camera, disconnect the power cord immediately, and consult your dealer (or a Sanyo Authorized Service Centre). Be careful when handling the unit To prevent damages, do not drop the camera or subject it to strong shock or vibration. Install away from electric or magnetic fields If installed close to a TV, radio transmitter, magnet, electric motor, transformer, or audio speakers the magnetic field they generate will distort the image. Protect from humidity and dust To prevent damage to the camera, do not install it where there is greasy smoke or steam, where the dampness may get too high, or where there is a lot of dust. Protect from high temperatures Do not install close to stoves, or other heat generating devices, such as spotlights, etc. , or where it could be subject to direct sunlight, as that could cause deformation, discoloration or other damage. Be careful when installing close to the ceiling, in a kitchen or boiler room, as the temperature may rise to high levels. Install where the temperature range will stay between ­10° C and 50° C. (no condensation) Cleaning Dirt can be removed from the housing by wiping it with a soft cloth. To remove stains, wipe with a soft cloth moistened with a soft detergent solution and wrung dry, then wipe dry with a dry soft cloth. Do not use benzine, thinners or other chemical products on the housing, as they may cause deformation and paint peeling. Before using a chemical cloth, make sure to read all accompanying instructions. Make sure that no plastic or rubber material comes in contact with the housing for a long period of time, as that may cause damage or paint peeling. Mounting Surface The mounting surface material must be strong enough to secure the camera. Plaster- board without a backing plate is not recommended. 2 English L5QA2/US, US2, L5QB2/US, US2, L7QA2/US, US2 GB 2002, 4, 24 INSTALLATION Dome assembly installation 72 mm Electrical Box Input Power Wires In-ceiling Type Main unit installation · Preparation (D) Video Out Cable (E) Make four or more holes in the ceiling or wall for the screws that are to be used to secure the main unit. If embedding the input power wire and video out cable, make a hole for these cables to be passed through also. · Main unit installation Housing assembly (H) Viewing Window (F) Housing assembly (C) Foam Gasket 1 2 (A) Dome assembly Use the accessory Allen key to remove the four screws (B) that are securing the dome assembly (A). Insert the foam gasket (C) in between the housing and the installation surface. Pass the input power wire (E) and video out cable (D) through the hole made for that purpose. [. . . ] The names and addresses of Authorized Sanyo Service Centers may be obtained by calling the toll-free number listed below. For product operation, authorized service center referral, service assistance or problem resolution, call CUSTOMER INFORMATION 1-800-421-5013 Weekdays 8:30 AM ­ 5:00 PM Pacific Time For accessories and/or parts, call PARTS ORDER INFORMATION 1-800-726-9662 Weekdays 8:30 AM ­ 5:00 PM Pacific Time THIS WARRANTY IS VALID ONLY ON SANYO PRODUCTS PURCHASED OR RENTED IN THE UNITED STATES OF AMERICA, EXCLUDING ALL U. S. THIS WARRANTY APPLIES ONLY TO THE ORIGINAL RETAIL PURCHASER OR END-USER. [. . . ]