User manual SANYO VCB-3524

[. . . ] IN NO EVENT SHALL SFC BE LIABLE FOR SPECIAL, INCIDENTAL OR CONSEQUENTIAL DAMAGES ARISING FROM OWNERSHIP OR USE OF THIS PRODUCT, OR FOR ANY DELAY IN THE PERFORMANCE OF ITS OBLIGATIONS UNDER THIS WARRANTY DUE TO CAUSES BEYOND ITS CONTROL. SOME STATES DO NOT ALLOW LIMITATIONS ON HOW LONG AN IMPLIED WARRANTY LASTS AND/OR DO NOT ALLOW THE EXCLUSION OR LIMITATION OF CONSEQUENTIAL DAMAGES, SO THE ABOVE LIMITATIONS AND EXCLUSIONS MAY NOT APPLY TO YOU. YOU MAY HAVE OTHER RIGHTS, WHICH VARY FROM STATE TO STATE. ATTENTION For your protection in the event of theft or loss of this product, please fill in the information below for you own personal records. Model No. ___________________________________________ Date of Purchase ____________________________________ Serial No. ___________________________________________ (Located on back or bottom side of unit. ) Purchase Price _____________________________________ Where Purchased _____________________________________________________________________________________________ 14 English Depending on the conditions of use, installation and environment, please be sure to make the appropriate settings and adjustments. [. . . ] ­ Consult the dealer or an experienced radio/TV technician for help. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. Changes or modifications not expressly approved by Sanyo may void the user's authority to operate this camera. ENGLISH 2 English PRECAUTIONS In case of problem Do not use the camera if smoke or a strange odour comes from the unit, or if it seems not to function correctly. Disconnect the power cord immediately, and consult your dealer (or a Sanyo Authorized Service Centre). Do not open or modify Do not open the cabinet, as it may be dangerous and cause damage to the unit. For internal settings and repairs, consult your dealer (or a Sanyo Authorized Service Centre). Do not put objects inside the unit Make sure that no metal objects or flammable substance get inside the camera. If used with a foreign object inside, it could cause a fire, short-circuits or damages. If water or a liquid gets inside the camera, disconnect the power cord immediately, and consult your dealer (or a Sanyo Authorized Service Centre). Be careful when handling the unit To prevent damages, do not drop the camera or subject it to strong shock or vibration. Install away from electric or magnetic fields If installed close to a TV, radio transmitter, magnet, electric motor, transformer, audio speakers the magnetic field they generate will distort the image. When the setting is complete, tighten the FLANGE BACK LOCK screw. MOUNTING THE LENS Check the lens mount Do not use a lens if the length "L" is more than 7 mm. That may damage the camera and prevent proper installation. L Installation of a DC type auto-iris lens (sold separately) A 1/3 inch CS mount type lens without EE amplifier circuit that only uses a DC power source. LENS switch to the DC type) a CS mount type lens without the need of an adaptor. If the lens plug shape or wiring does not correspond, please install the supplied plug as indicated in the pin layout table. 6 English MOUNTING THE LENS 2 (A) (B) Installation of a VIDEO type auto-iris lens (sold separately) A 1/2 or 2/3 inch C mount type lens with EE amplifier circuit that uses the video signal and a DC power source. 1 2 3 1 2 4 3 Remove the lens mount cap. Attach the supplied C mount adaptor (A) to the auto-iris lens (B), then install the assembly on the camera. Connect the lens plug to the LENS connector on the side of the camera. If the lens plug shape or wiring does not correspond to the specifications below, connect the supplied plug as indicated. · Cable type RG-39U, 200 m maximum. CAUTION: The RG-59U type cable should not be run through electrical conduits or through the air. (Video signal connections) : VIDEO IN : VIDEO OUT English 9 SETTINGS VR401 L EI ON OFF ON E V E L HL DC VIDEO BLC A. LENS Electronic iris function setting Use a manual or fixed iris lens and set the lens aperture to the shortest F stop. Set the EI/BLC switch to EI-ON position. EI ON OFF ON Note: Please refer to the specifications for dynamic range of the electronic iris. BLC CAUTION: · The electronic iris is suitable for normal indoor use. When the EI/BLC switch is set to the EI-ON position, do not use an auto-iris lens. [. . . ] If more than two cameras are used, please repeat this procedure for all the cameras. CAUTION: If the vertical roll cannot be corrected by setting the LINE PHASE volume on camera 2, try setting the LINE PHASE volume on camera 1. If it still cannot be corrected, please check that the polarity of the power cords of all connected devices is correct. English 11 TROUBLESHOOTING Before taking the camera for repairs, please check below to make sure that the camera is used correctly. If it still does not perform correctly, please consult your dealer or a Sanyo Authorized Service Centre. No picture on the monitor screen Is the power turned on to all connected devices? [. . . ]