User manual SANYO SC-X1000P

[. . . ] Children should be supervised to ensure that they do not play with the appliance. This appliance is not intended for use by persons (including children) with reduced physical, sensory or mental capabilities, or lack of experience and knowledge, unless they have been given supervision or instruction concerning use of the appliance by a person responsible for their safety. Do not pull or carry by cord, pedal cord, use cord as a handle, close a door on cord, or pull cord around sharp edges or corners. [. . . ] Do not pull or carry by cord, pedal cord, use cord as a handle, close a door on cord, or pull cord around sharp edges or corners. Do not use with any opening blocked; keep free of dust, lint, hair, and anything that may reduce air flow. Keep hair, loose clothing, fingers, and all parts of body away from openings and moving parts. Before the first operation, make sure the dust cup is properly installed. Do not use the machine without HEPA filter and motor protection filter in 1 · · Blocking the suction inlet will decrease the efficiency of the motor. *Inflammable materials or combustible liquids such as gasoline and thinner. The following kinds of treatment shorten hose lifetime: *Bending hose at an acute angle when storing. *Pulling the hose with excessive force *Placing heavy objects on, or stepping on the hose. This vacuum cleaner can be used as tip the rubbish out of the full dust cup. Figure_1 Figure_2 Figure_3 Figure_4 2. Clean Filters: HEPA filter; 1) Open the front cover: Press the buttons at the both side of socket hole and open it slowly. Be sure to dry naturally to prevent deformation. Figure_12 Figure_5 Figure_6 Figure_7 Figure_8 Motor exhaust filter; 1) Take out the filter (Figure_13, 14) and wash in warming water. It can be used after drying completely before put it back to the dust cup and be sure to dry naturally to prevent deformation. If the filter is damaged, a new filter should be replaced. Figure_9 Figure_10 Figure_11 Maintenance CAUTION Be sure to turn the power off and unplug the unit before cleaning. Clear the dust: when the dust collect to the MAX label of the filter, rubbish shall be tipped from the dust barrel. 1) Press the front cover clip beside the suction socket and open the front cover. 3) Clean the dust cup with warm water if necessary. Figure_12 Figure_13 Figure_14 5 6 Technical Specification Input power : Input voltage : Protection class: Power cord length: Dust capacity : 1800W 230-240V , 50Hz class ll 5m 2L Trouble Shooting If you have a problem with your cleaner, consult the handy guide as below. If the cleaner is malfunctioning, do not operate it before asking for service. Problem Noisy operation Low Suction Possible Solution Clean the filter and clean up the inside of the dust cup. [. . . ] 1) Press the front cover clip beside the suction socket and open the front cover. 3) Clean the dust cup with warm water if necessary. Figure_12 Figure_13 Figure_14 5 6 Technical Specification Input power : Input voltage : Protection class: Power cord length: Dust capacity : 1800W 230-240V , 50Hz class ll 5m 2L Trouble Shooting If you have a problem with your cleaner, consult the handy guide as below. If the cleaner is malfunctioning, do not operate it before asking for service. Problem Noisy operation Low Suction Possible Solution Clean the filter and clean up the inside of the dust cup. [. . . ]