User manual SANYO RM-CD23

[. . . ] USE OF CONTROLS, ADJUSTMENTS OR PROCEDURES OTHER THAN THOSE SPECIFIED HEREIN, MAY RESULT IN HAZARDOUS LASER LIGHT BEAM EXPOSURE. THIS COMPACT DISC PLAYER SHOULD NOT BE ADJUSTED OR REPAIRED BY ANYONE EXCEPT QUALIFIED SERVICE PERSONNEL. THE LASER MECHANISM IN THE SET CORRESPONDS TO THE STYLUS (NEEDLE) OF A RECORD PLAYER. ALTHOUGH THIS PRODUCT USES A LASER PICK-UP LENS, IT IS COMPLETELY SAFE WHEN OPERATED ACCORDING TO DIRECTIONS. outdoors into a warm room, or if it is in a cold room which is heated quickly. [. . . ] To backward skip and forward skip the track, Press the CD Skip/Search button ( or ) during play to skip to the desired track. Press the CD Forward Skip/Search button ( ) to skip to the next track on the disc. Press the CD Backward Skip/Search button ( ) to skip to the beginning of the track currently playing. n Press and hold the CD Skip/Search button ( or ) during play to scan the disc at high speed. When the desired section of the disc is found, release the buttons; normal play will resume. Press the Program/Repeat button during play: n Press once to repeat the track (song) currently played, The repeat indicator will come on. n Press twice to repeat all the tracks (songs) on the disc, The repeat indicator will flash on and off. After the current track is finished, the unit will play tracks in random order until all tracks are played, and then stop. During random play, the current track number and random symbol will flash repeatedly to indicate random play is in progress. PROGRAM PLAY PROGRAM BUTTON Tracks on the disc can be played in the desired pre-set order. Press CD Program/Repeat button again to store the first track into memory. Repeat steps 2 to 3 to program additional tracks; up to 16 tracks can be programmed in sequence. Note: When the 10th track is programmed, the display shows " ". When more than 10 tracks are entered, the display will show , , , , and indicating11, 12, 13, 14, 15 and 16th track. The Display will show the track number being played, and the Play/Program indicator will remain flashing during programmed play. If in middle of play if you want to hear the next programmed track, press the Skip/Search button ( ). Note: Programming can only be done when the CD is in the stop mode. 7 8 TO SET CLOCK TIME Press and hold Time Set button. While holding down Time Set button, press Forward button or Reverse button until desired time is displayed. Note: A green dot (PM Indicator) in the lower right corner indicates PM time. Note: When setting time, be careful not to touch Snooze and/or Sleep button. WAKE TO ALARM Set the proper alarm time or check if the pre-set alarm time is correct by pressing the Alarm set button. Press the Alarm Off button to furn off the alarm. WAKE TO RADIO Turn radio on (slide Function switch to RADIO) and adjust the Tuning and Volume control. Set the proper alarm time or check if the pre-set alarm time is correct by pressing the Alarm set button. [. . . ] or to an authorized Sanyo Service Depot when you make a claim under this Warranty. You, the original retail purchaser, are responsible for any costs of TRANSPORTING the product to and from SANYO Canada Inc. You also are responsible for the cost of any MAINTENANCE necessary in respect of the product. WARRANTY BECOMES VOID This warranty becomes void if the product's serial numbers are altered or removed or if any repair to the product is made other than by SANYO Canada Inc. [. . . ]