User manual SANYO RM-5750

[. . . ] INSTRUCTION MANUAL AM/FM Digital Alarm Clock Radio RM-5750 Fig. 1 CAUTION: THE APPARATUS SHALL NOT BE EX- POSED TO DRIPPING OR SPLASHING. [. . . ] During the mains interruption, the clock display will go out, but the clock movement remains in operation. When the mains lead is connected to the AC outlet for the first time, or when the mains returns after a failure longer than the battery life, the display will blink. In this case, set the clock and timer again. POWER SUPPLY Connect the mains lead to an AC 230V, 50Hz wall outlet. The unit is not disconnected from mains, even switched off. Earphone Connect the 1/8-inch (3. 5mm) earphone (not supplied) to the EAR socket for (mono output) on the back of the radio for monitoring or for private listening. The speakers are automatically disconnected when the earphone is connected. ADJUSTING THE CLOCK 1. While holding the TIME SET button down, push the HOUR or MINUTE button respectively to select the current time. . Aerials - For AM reception, rotate or relocate the unit to a different position to improve the reception of a distant or weak station. Unwind the short wire aerial and extend it to full length. SETTING THE ALARM 1. While holding the ALARM button down, push the HOUR or MINUTE button respectively to select the alarm time. Note: If you want to check the time setting, simply push the ALARM button. 5 USING THE ALARM 1. [. . . ] Rotate VOLUME knob to select the desired sound level. 7 SPECIFICATIONS Output power: 350 m Watts (AC max. ) Speaker 6 cm Tuning ranges: AM: 510- 1650kHz FM: 87 - 108. 5 MHz Antennas: Built-in ferrite bar and antenna lead wire Power source: AC: 230 V, 50 Hz DC: 9 V (Clock black-up, 006P type, not supplied) Power consumption: Approx. 150 x 55 x 144 mm Specifications subject to change without notice. Made in China [. . . ]