User manual SANYO PLCSP10N

[. . . ] Before you do, we suggest that your spend a little time reading this manual to familiarize yourself with the operating procedures so that you will receive maximum satisfaction from the many features included in your new projector. This owner's manual will acquaint you with your projector's features. Through the years, we have found that many service requests were not caused by problems with our projectors. They were caused by problems that could have been prevented, if the owner had followed the instructions in the manual. [. . . ] Press the POINT LEFT/RIGHT buttons to select IMAGE and press the SELECT button. Move the arrow to the item that you want to change by pressing the POINT UP/DOWN buttons. To change the value, press either the POINT RIGHT button or the POINT LEFT button. It indicates the level of the item. Fine sync. Adjust the picture as necessary to eliminate flicker from the display. (From 0 to 127. ) Total dots The number of the total dots in one horizontal period. White balance (Red / Green / Blue) Move the arrow to Red, Green, or Blue that you want to adjust. Press POINT LEFT button to adjust the color of image lighter, and press POINT RIGHT button to adjust deeper. (From 0 to 63. ) Contrast Press POINT LEFT button to adjust the image lighter, and press POINT RIGHT button to adjust deeper. (From 0 to 63. ) Brightness Press POINT LEFT button to adjust the image darker, and press POINT RIGHT button to adjust brighter. Closes the PICTURE IMAGE ADJUSTMENT Menu. Move the arrow to the item and press POINT RIGHT / LEFT button. Close the PICTURE IMAGE ADJUSTMENT Menu. NORMAL FUNCTION The normal picture level is preset on this projector at the factory and can be restored anytime you press the NORMAL button (located on the Top Control or on the Remote Control Unit). The "Normal" display will be displayed on the screen for a few seconds. Normal 27 COMPUTER MODE AUTO IMAGE FUNCTION The Auto Image function is provided to automatically adjust Fine sync. , Total dots, and Picture Position for most computers. 1 2 Press the MENU button and the ON-SCREEN MENU will appear. Refer to the following for operation. Expand function To expand the image size, press the D. ZOOM v button or the SELECT button. The maximum size of the projected image in expand mode is 4 times as large as the screen size (800 x 600). Compress function To compress the image size, press the D. ZOOM w button or the RIGHT CLICK button. The minimum size of the projected image in compress mode is 640 x 480 in VGA or 800 x 600 in SVGA / XGA. Panning function To pan the image, press the POINT UP/DOWN/LEFT/RIGHT buttons. Panning function can work only when the image is larger than the screen size. To cancel Digital Zoom mode, press the any buttons except D. ZOOM v/w, SELECT, RIGHT CLICK, POINT, PAGE v/w or LASER button. To adjust the image to the screen size (800 x 600), press NORMAL button. q This projector cannot display in the resolution higher than 1024 X 768. If your computer's screen resolution is higher than 1024 X 768, reset the resolution to the lower before connecting the projector. q The image data in other than SVGA (800 x 600) is modified to fit the screen size in the initial mode. q The normal "Panning Operation" may not function properly if the computer system prepared with the "PC Adjust" is used. 29 VIDEO MODE SELECTING VIDEO MODE DIRECT OPERATION Select VIDEO mode by pressing the MODE button on the Top Control or the VIDEO button on the Remote Control Unit. MODE button COMPUTER MCI MENU OPERATION Press the MENU button and the ON-SCREEN MENU will appear. [. . . ] q Check the ALL-OFF switch on the Remote Control Unit is set to "ON. ". q Make sure anything is blocking between the Remote Receiver and the Remote Control Unit. q Make sure you are not too far from the projector when using the Remote Control Unit. q Check Control Cable for Serial Port (optional) is connected properly. [. . . ]