User manual SANYO PLC8800N

[. . . ] Before you do, we suggest that you spend a little time reading this manual to familiarize yourself with the operating procedures, so that you will receive maximum satisfaction from the many features included in your new projector. This owner's manual will acquaint you with your projector's features. Through the years, we have found that many service requests were not caused by problems with our projectors. They were caused by problems that could have been prevented, if the owner had followed the instructions in the manual. [. . . ] Move the arrow to the language you want to use by pressing the POINT UP/DOWN BUTTON(s) and then press the SELECT (REAR CLICK) BUTTON. The setting is permanently held even if the MAIN ON/OFF is switched off. MAIN MENU DISPLAY LANGUAGE SETTING DISPLAY ­ 30 ­ COLOR SYSTEM SELECT (VIDEO MODE) This projector is compatible with the five major broadcast video standards: PAL, SECAM, NTSC, NTSC 4. 43 and PAL-M (COLOR SYSTEMs). It automatically adjusts itself to optimize its performance for the incoming video (Except PAL-M). However, if the video signal is not strong enough to detect the video format, the projector may not reproduce the proper video image. In case this happens, this projector allows you to choose a specific broadcast signal format. Connect the video equipment to the PROJECTOR, and turn them on projector first. Press the MENU BUTTON and the MAIN MENU DISPLAY dialog box will appear. Press the POINT LEFT/RIGHT BUTTON(s) to select SYSTEM and press the SELECT (REAR CLICK) BUTTON. To change the current COLOR SYSTEM, press the POINT UP/DOWN BUTTON(s) to move the arrow to a desirable system and then press the SELECT (REAR CLICK) BUTTON. The setting changed remains effective until the MAIN ON/OFF switch is turned off. MAIN MENU DISPLAY COLOR SYSTEM DISPLAY ­ 31 ­ PICTURE IMAGE ADJUSTMENT (VIDEO MODE) Although picture adjustments have been preset at the factory, you may want to change the setting. To switch to "Regular" mode, move the arrow to Regular by pressing the POINT UP/DOWN BUTTON(s) and then press the SELECT (REAR CLICK) BUTTON. The "Wide" settings remains effective until the MAIN ON/OFF switch is turned off. MAIN MENU DISPLAY SCREEN ADJUST DISPLAY ­ 33 ­ COMPUTER SYSTEM SELECT (COMPUTER MODE) This projector is adjustable to different types of computer display signals based on VGA, SVGA or XGA (See "COMPATIBLE COMPUTER SPECIFICATIONS" on the next page). If you set MODE SELECT to "COMPUTER", the projector will automatically process the incoming signal and project the proper image without any special setting. Although this will work in most cases, you may be required to manually set the projector for some computer signals. If the computer image is not reproduced properly, try the following procedure and switch to the computer display mode that you want to use. Connect the COMPUTER to the PROJECTOR, and turn them on projector first. This shows the current display mode initially detected by the projector in the system window. If the projector cannot discriminate or detect the input signal from the computer, the "Go PC adj. " display appears. If no input signal from the computer, the "No signal" display appears on the screen. Press the MENU BUTTON and the MAIN MENU DISPLAY dialog box will appear. Press the POINT LEFT/RIGHT BUTTON(s) to select SYSTEM and press the SELECT (REAR CLICK) BUTTON. [. . . ] ¡Make sure you are not too far from the projector when using the remote control unit. ¡Check the cable connection between the projector and the computer. ¡Turn on the projector before you turn on the computer. Picture is T/B inverted. No sound. Remote control unit doesn't work. Wireless mouse function does not work. SERVICE WARNING: High voltages are used to operate this projector. [. . . ]