User manual SANYO MCD-ZX540F

[. . . ] Doing so may produce an excessively large output from the amplifier which could damage your speakers. Sudden change in the ambient temperature may cause condensation to form on the optical lens inside the unit. If this happens, take out the disc, leave the unit for about 1 hour, and then proceed to operate. Where the MAINS plug or an appliance coupler is used as the disconnect device, the disconnect device shall remain readily operable. - - To be completely disconnect the power input, the mains plug of apparatus shall be disconnected from the mains. [. . . ] The speakers are automatically disconnected when headphones are connected. - Excessive sound pressure from earphones and headphones can cause hearing loss. Press the SURROUND button to Z ON, a 3 dimensional sound effect is created. -3- 540AU. indd 3 2009. 4. 8 10:11:12 AM CD PLAY Use compact discs bearing the symbol shown below. In addition to conventional 12cm CDs, this system can be used to play 8cm CDs without an adapter. Always press the STOP n button and wait for the disc to stop rotating before opening the CD compartment. However, some CD-R/RW can not be played back depending on the recording conditions. Notes on handling compact discs - Do not expose the disc to direct sunlight, high humidity or high temperature for extended periods of time. - Fingerprints and dust should be carefully wiped off the playing surface of the disc with a soft cloth. - Never use chemicals such as record cleaning sprays, antistatic sprays or fluids, benzene or thinner to clean compact discs. 1. Place the disc with the label facing up on the turntable as shown below. Press the PLAY/PAUSE i button. Temporarily stopping play Press the PLAY/PAUSE i button, "a" blinks on the display. To resume play, press the button again. Skip play The current track number appears. - To start play from the desired track, select the track by using the f or e button, then press the PLAY/PAUSE i button. Note: If no disc is loaded or the disc is located with the label facing down "00" appears. To turn the CD player off, set the FUNCTION switch to TAPE/OFF . To skip to track 6 while track 3 is playing, press the e button repeatedly until "6" appears on the display. To skip back to track 3 while track 6 is playing, press the f button repeatedly until "3" appears. Search (forward/reverse) If the e or f button is pressed during play, the player will search at high speed in the forward or reverse direction while the button is being pressed. When the button is released, normal play will continue. -4- 540AU. indd 4 2009. 4. 8 10:11:15 AM Repeat playing mode Press the REPEAT button repeatedly to select a repeat play mode available. Each time the button is pressed, the mode changes as shown below: [CD] "REPEAT" blinks (Repeat one track) "REPEAT" appears (Repeat all tracks) 5. "MEMORY" remains lit. MEMORY Released (Normal play) When all programmed tracks have been played, the player stops automatically. Any attempt to programme more than 20 tracks will result in discontinuous of the programming. To cancel programmed play, press the STOP n button twice during play. PROGRAMMED PLAY Up to 20 tracks on a disc can be programmed for play in any order. - To begin the programming procedure, set function switch to "CD" first. - Load a disc that you want to programme before starting programmed play. [. . . ] They may jam in the mechanism. -6- 540AU. indd 6 2009. 4. 8 10:11:20 AM LISTENING TO THE RADIO 1. To turn the radio off, set the FUNCTION switch to TAPE/OFF or CD or LINE IN. To receive FM stereo broadcasts Set the FM MODE select switch (the back of the unit) to ST. - If the signal from an FM stereo station is weak and reception is poor, set the FM MODE select switch to MONO. [. . . ]