User manual SANYO LNSW01

[. . . ] LNS-W01 LNS-T01 LENS REPLACEMENT AND INSTALLATION PROCEDURE q The focus and zoom of this lens can't be adjusted by controls on main cabinet or the remote control unit. NOTES ON LENS INSTALLATION Lens installation should be performed by the qualified service personnel. [. . . ] D B 2 q IN CASE OF MODEL WITHOUT LENS A D Fig-1 LOWER LENS COVER REMOVE THE COVER PLATE OF THE LENS COVER. (At the step 4 , insert the light-block sheet in the same position as the removed cover plate has been placed. Two screws are not used. ) Set the light-block sheet, so that the large rounder side is set over the lens. COVER PLATE Fig-2 LENS MOTOR (D) q IN CASE OF MODEL WITH LENS REMOVE THE LENS. Remove screws D (4 screws) which fastens the lens and remove the lens. p Figure shown inside of the cabinet. (D) A (D) (D) B A LENS MOTOR LEAD CONNECTOR " K16B" Fig-3 3 INSTALL THE LENS. (After using, save it for latter use. ) ATTACHED DRIVER Fig-4 4 INSTALL THE LIGHT-BLOCK SHEET. (See figure-5) Install the light-block sheet around the lens as shown in the illustration. FOCUS LENS LOCK SCREW When this projector permanently install in the structure, slide the picture, obtain correct focus, then lock the lens by Focus Lens Lock screw at this step. Adjust focus by rotating the lens. LIGHT-BLOCK SHEET Fig-5 5 MOUNT THE LENS COVER. [. . . ] Insert the upper part lens cover and fix them with screws A (4 screws). A 2. [. . . ]