User manual SANYO LNSS02 INSTALL GUIDE

[. . . ] LNS-S02 LENS REPLACEMENT AND INSTALLATION PROCEDURE NOTES ON LENS INSTALLATION Lens installation should be performed by the qualified service personnel. [. . . ] Pull down the lower lens cover while pushing the part D, then remove it. D D A B Fig-1 LOWER LENS COVER 2 REMOVE THE COVER PLATE OF THE LENS COVER. (At the step 4 , insert the light-block sheet in the same position as the removed cover plate has been placed. Mount the lens on mounting bracket of the main cabinet with 4 screws. Use the screws included with the lens. Connect the lead connector of the lens motor to the "K16B" on the circuit board as shown in figure-4. Fasten the lens motor lead at the A, B points with wire holder as shown in figure-4. ATTACHED DRIVER LENS MOTOR LENS MOUNTING BRACKET Fig-3 p Figure shown inside of the cabinet. (D) (D) LENS MOTOR (D) (D) B A WIRE HOLDER LENS MOTOR LEAD CONNECTOR " K16B" Fig-4 4 INSTALL THE LIGHT-BLOCK SHEET. (See figure-5) Set the light-block sheet, so that the large rounder side is set over the lens. Install the light-block sheet around the lens as shown in the illustration. [. . . ] Insert the upper part lens cover and fix them with screws A (4 screws). [. . . ]