User manual SANYO LNS-W05 LENS INSTALLATION AND REPLACEMENT PROCEDURES

[. . . ] LNS-W04/LNS-W05/LNS-W06/LNS-W07 LENS INSTALLATION AND REPLACEMENT PROCEDURES NOTES ON REPLACEMENT AND INSTALLATION The procedures and the needed pars for lens installation depend on the type of cabinet. Before installing or replacing the lens, make sure the type of cabinet of your projector and install the lens following this procedure precisely. [. . . ] · LENS 1 pc · DRIVER 1 pc BE SURE TO CHECK THE FOLLOWING MATTERS FOR SAFETY After installing or replacing the lens, be sure to confirm the followings for safety. Make sure no part is missing, or loose. Not all the parts included may be used for lens installation or replacement. Note : Illustrations in this manual may differ from the actual product. -1- LENS REPLACEMENT AND INSTALLATION PROCEDURE A 1 Disconnect the power cord from AC outlet. (See Fig-1. ) A A Front Cover Fig-1 2 Pulling up Light Block Sheet Holder and Cover Plate, remove them. (See Fig-2) Light Block Sheet Holder Cover Plate Fig-2 3 Remove the cover plate from the light block sheet holder . (See Fig-3) Cover Plate Fig-3 -2- 4 Remove lens cap on the rear (mounting side) of the projection lens and mount Lens Attachment to the lens with four screws included with the lens. Insert the connector at the end of Lens Motor Lead into the socket located at right-top of the lens attachment. (With motor model only. ) Note : Lens attachment is not included in this lens. Lens Attachment POA-LNA-04 (610 317 1289) Lens Attachment Socket Connector Locate motor on right side. (610 275 6029) Lens Motor Lead Fig-4 Lens Attachment Driver included with the lens Part No. (610 275 6029) Note : Lens Illustrations in this manual may differ from the actual product. 5 Pinch Lens Lock Lever and turn it clockwise to unlock. (See Fig-5. ) Insert the Lens through the lens mounting bracket and turn the lens lock lever anticlockwise until the lens is securely mounted. After installing the lens, make sure the Lens is not loose and properly mounted. [. . . ] Improper installation may cause the lens malfunction. Light Block Sheet LNS-W04/LNS-W05/LNS-W06 TYPE F14A (610 315 7337) LNS-W07 TYPE F14B (610 315 7320) Light Block Sheet Holder Fig-8 Fig-9 w Back Back of Light Block Sheet To unfold, reverse the light block sheet and release the latch. Front Cover q 7 Replace the front cover and secure it with the 5 screws. Fig-10 -5- [. . . ]