User manual SANYO LCD22VT10DVD

[. . . ] INSTRUCTION MANUAL LCD-22VT10DVD(C) LCD TV WITH DVD PLAYER Before connecting, operating or adjusting this product, please read the manual completely. Please keep this manual for future reference. Contents Features . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 2 Accessories . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 2 Introduction . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . [. . . ] Select "Language" item in the Setup menu and press OK button. Then language settings menu will be displayed. Automatic Channel Scan Automatic channel scan is started by pressing OK button while Automatic channel scan item is highlighted. The following message appears on the screen: You can set the desired language options by using " " /" " and " "/" " buttons. Note: If the Country option is set to Denmark, Sweden, Norway or Finland, the Language Settings menu will function as described below: Highlight Yes or No by using " " or " " buttons and press OK button to confirm. After search is completed for digital channels, a message asking whether to search for analogue channels appears on the screen: Language Settings . Highlight Yes and press OK button to search for analogue channels. The following menu appears on the screen for analogue channel search: English - 18 - First Time Installation The user can use this item to load default settings, which were loaded to the receiver at the factory. To install factory settings, highlight "First Time Installation" menu item and press OK button, then you will be asked whether or not to delete the settings. Selecting "Yes" by pressing OK button while the "Yes" is highlighted, will delete the existing channel table. Set Language item by pressing " " or " " button. Press " " or " " button to highlight Country item and then use " " or " " to set. Press " " or " " button to highlight TXT Language. To cancel, press the BLUE button. After factory settings are loaded, "First Time Installation" menu will be displayed. Turn off the TV via remote control, unplug the power cord, plug the power cord and turn on the TV again. After APS is finalized, the programme table will appear on the screen. In the programme table you will see the programme numbers and names assigned to the programmes. Press OK button to activate power save mode. If you select Store Mode, the following OSD will be displayed after every standby on/off. Picture and Backlight preferences will be changed when you activate Power Save Mode. The menu which is displayed for language selection appears on the screen at first. By using " " or " " buttons, select the desired language option, and press OK button to activate. After then, "First time installation" OSD will appear on the screen. By pressing " " or " " buttons, select the Country you want to set and press OK button (* only for EU countries). After active antenna mode option is selected, a message asking for automatic search appears on the screen: Manual Search In Manual Search, the number of the multiplex is entered manually and only that multiplex is searched for the channels. For every valid channel number, signal level and signal quality are shown on the screen. In both manual and auto search any existing channel in the database is not re-stored to avoid redundant duplicates of that channel. Frequency Search Enter the desired frequency. [. . . ] After you have entered your old password, you can now enter the new 4-digit password. You have to enter XXXX digital password every time you want to change the parental level. If you forget your password please contact technical service. Some functions (Angle, Zoom etc) do not work · These functions are not available on the DVD. · Angle can only be changed when the angle symbol is displayed. No picture · Have you pressed the correct buttons on the remote control? [. . . ]