User manual SANYO KMHS2472

[. . . ] · INSTRUCTION MANUAL · MODE D'EMPLOI Inverter-Controlled Split System Air Conditioner Climatiseur de type séparé contrôlé par inverseur KMHS1872 KMHS2472 This air conditioner uses the new refrigerant R410A. COOL/DRY/HEAT Model Save These Instructions!OI-85264180809000 © SANYO 2006 Features This air conditioner is an inverter type unit that automatically adjusts capacity as appropriate. Details on these functions are provided below; refer to these descriptions when using the air conditioner. · Microprocessor Controlled Operation The interior compartment of the remote control unit contains several features to facilitate automatic operation, easy logically displayed for easy use. [. . . ] 60 °F min. STEP 2 STEP 3 Set the FAN SPEED selector button to the setting you want. (Refer to "Adjusting the Airflow Direction" on page 21. ) To stop the air conditioner, press the ON/OFF operation button again. NOTE When multiple indoor units are used and units in other rooms are already operating, they will be set to the same mode of operation as the operating indoor units. OI-809-13-EG 13 Operation with the Remote Control Unit (continued) NOTE · Choose the best position in the room for the remote control unit, which also acts as the sensor for room comfort and transmits the operating instructions. Once you've found this best position, always keep the remote control unit there. This appliance has a built-in 5-minute time delay circuit to ensure reliable operation. When the operation button is pressed, the compressor will start running within three minutes. Manual fan speed Simply set the FAN SPEED selector button to the position. If you want to adjust fan speed manually during operation, just set the FAN SPEED selector button as desired. [ , , or ] 14 OI-809-14-EG Operation with the Remote Control Unit (continued) 4. To release the night setback function, press the NIGHT SETBACK button again. A. In Cooling and DRY Mode: ( and ) When the night setback mode is selected, the air conditioner automatically raises the temperature setting 2 °F when 30 minutes have passed after the selection was made, and then another 2 °F after another 30 minutes have passed, regardless of the indoor temperature when night setback was selected. This function is convenient when gentle cooling is needed. 2 °F Setting temperature 2 °F Press the NIGHT SETBACK button B. Time When the night setback mode is selected, the air conditioner automatically lowers the temperature setting 4 °F when 30 minutes have passed after the selection was made, and then another 4 °F after another 30 minutes have passed, regardless of the indoor temperature when night setback was selected. Setting temperature 4 °F 4 °F Press the NIGHT SETBACK button 30 min. 30 min. Time OI-809-15-EG 15 Operation with the Remote Control Unit (continued) 5. QUIET Mode QUIET Mode is used to reduce the fan sound of the indoor unit. · · In QUIET Mode, the fan rotates at a slower speed than the fan speed setting. If the unit is already operating with a very low airflow, the fan sound may not change even if the QUIET button is pressed. 6. HIGH POWER Mode HIGH POWER mode can be used to increase the output of the indoor unit for all operation modes except automatic operation. · When the HIGH POWER button is pressed, the unit operates at maximum output for 30 minutes, regardless of the desired temperature. HIGH POWER Mode cannot be used when the operation mode is Automatic Operation. NOTE · When set to High fan speed during heating operation, the fan runs at High fan speed even though the mark is displayed. · Depending on the operating conditions, the fan speed may be increased by a small amount only. · · 7. [. . . ] Allow the edge of the air intake grille to slide into the top of the indoor unit, and then insert it all the way inside. To attach the air intake grille to the indoor unit, press its bottom right and left corners as well as its bottom center into place. Air intake grille NOTE Attach so that the round pins at the top right and left corners of the air intake grille are inserted into the grooves at the top right and left of the indoor unit. OI-809-23-EG 23 Care and Cleaning (continued) Air Clean Filter The air clean filter removes dust and dirt from the air, and reduces odors and smoke from tobacco. This air clean filter cannot remove harmful gases or vapors nor ventilate air in the room. You must open doors or windows frequently when you use gas or oil heating appliances. [. . . ]