User manual SANYO DP32648

[. . . ] When shipping the projector with the lens, remove the lens before shipping the projector. If you have any questions, contact the dealers. LIST Of CONTENTS following parts are included in the packing. · LENS CAP front and rear (Each 1 pc. ) · SCREW DRIVER 1 pc. [. . . ] · INSTALLATION MANUAL 1 pc. BE SURE TO ChECK fOR SAfETy After installing or replacing the lens, be sure to check the following for safety. Check no part is missing, or no mounting part is loose. Some parts are not used for installation or replacement. -1- LENS REPLACEMENT AND INSTALLATION PROCEDURE 1 T urn off the projector, press the Main On/Off Switch to Off and unplug the AC power cord from the AC outlet. T urn the Lens Mount Cover counter-clockwise and take it off by pulling forward. 1) 5 This projector can use three (3) different types of Light-Block Plates, use the Light-Block Plate that corresponds to the appropriate optional lens. Make sure the mark (UP/DOWN and FRONT/ BACK) on Light-Block Plates are correct and set them properly. Light-Block Plate Type FK2A (610 337 0064) 2 Lens Mount Cover Fig. 1 NOTE: The Light-Block Plate FK2A is separated to the upper and lower plates. UP Upper Plate Lower Plate 3 Remove 2 Screws A and loosen 2 Screws B. 9-1 R eplace and fix the Top Cover with two (2) Screws A and 2 screws B. 11) Top Cover A A Safety Clamp Attached Figure B Safety Clamp (SC-A) Part No. 9-2 -4- 12 Fit the raised dot of the Lens Mount Cover to the leftmost edge of the Seal on the projector, and then turn the Lens Mount Cover clockwise and adjust the position of the raised dot to the one of the projector. 12) NOTE: If not mounted properly, the Lens Mount Cover may fall, causing hazards of injuly. Label Dot on the cabinet Dot on the lens mount cover FOCUS CORRECTION When the lens is attached to the projector and images are being projected onto the screen, the peripheral focus may be out of focus in some localized areas. If this happens, insert the one, of three sizes of spacers, in between the Lens Attachment and the lens to adjust the focus. Inserting the Spacer corrects the distance on the Lens Adjustment and improves the diagonal focus. The corrected distance is determined by the thickness of the used spacers. As a guide, the distance is adjusted by approximately 30 mm for each 0. 1-mm thickness of the spacers. [. . . ] The corrected distance is determined by the thickness of the used spacers. As a guide, the distance is adjusted by approximately 30 mm for each 0. 1-mm thickness of the spacers. There are three types of spacers supplyed with the projector, and there are four of each spacer type. [. . . ]